Trying to figure out how to talk to the touchscreen properly on
sc7280-herobrine boards was a long and difficult process. Many
Engineering hours were spent deciding how exactly one should talk over
i2c to a peripheral. In the end, a solution has been found and this
patch series attempts to implement it in a way that will work for all
herobrine-based boards.
Validation of this code has actually been done on
sc7280-herobrine-villager. Those patches are device-tree only and are
placed first. They shouldn't be super controversial, I hope.
In order to make this work, we also need to support
sc7280-herobrine-evoker. For evoker, things are a bit tricker, though
(I think) the solution we ended up with is not terrible. See the
"Goodix" bindings patch for the full details. Unfortunately, I haven't
tested the final version of these patches on evoker hardware. Thus
those patches are at the end of the series and marked as such. It
still wouldn't hurt to land them, if people are OK with it, since
nobody in the wild has this hardware and and the evoker-specific parts
of the patch are very easy to validate.
Douglas Anderson (7):
arm64: dts: qcom: sc7280: On QCard, regulator L3C should be 1.8V
arm64: dts: qcom: sc7280: Add 3ms ramp to herobrine's
pp3300_left_in_mlb
arm64: dts: qcom: sc7280: Hook up the touchscreen IO rail on villager
HID: i2c-hid: goodix: Stop tying the reset line to the regulator
dt-bindings: HID: i2c-hid: goodix: Add mainboard-vddio-supply
HID: i2c-hid: goodix: Add mainboard-vddio-supply
arm64: dts: qcom: sc7280: Hook up the touchscreen IO rail on evoker
.../bindings/input/goodix,gt7375p.yaml | 7 ++
.../dts/qcom/sc7280-herobrine-evoker.dtsi | 1 +
.../dts/qcom/sc7280-herobrine-villager.dtsi | 1 +
.../arm64/boot/dts/qcom/sc7280-herobrine.dtsi | 2 +
arch/arm64/boot/dts/qcom/sc7280-qcard.dtsi | 10 +-
drivers/hid/i2c-hid/i2c-hid-of-goodix.c | 98 +++++--------------
6 files changed, 42 insertions(+), 77 deletions(-)
--
2.39.1.519.gcb327c4b5f-goog
