On 24/01/2023 12:13, Manuel Traut wrote: > This patch adds the documentation for the devicetree bindings to set > the volume levels. Please use scripts/get_maintainers.pl to get a list of necessary people and lists to CC. It might happen, that command when run on an older kernel, gives you outdated entries. Therefore please be sure you base your patches on recent Linux kernel. > > Signed-off-by: Frieder Schrempf <frieder.schrempf@xxxxxxxxx> I think it is kontron.de now. > Acked-by: Rob Herring <robh@xxxxxxxxxx> This misses your SoB. > --- > .../devicetree/bindings/input/pwm-beeper.txt | 11 +++++++++++ > 1 file changed, 11 insertions(+) > > diff --git a/Documentation/devicetree/bindings/input/pwm-beeper.txt b/Documentation/devicetree/bindings/input/pwm-beeper.txt > index 8fc0e48c20db..93cab5eee9f2 100644 > --- a/Documentation/devicetree/bindings/input/pwm-beeper.txt > +++ b/Documentation/devicetree/bindings/input/pwm-beeper.txt > @@ -9,6 +9,15 @@ Required properties: > Optional properties: > - amp-supply: phandle to a regulator that acts as an amplifier for the beeper > - beeper-hz: bell frequency in Hz > +- volume-levels: Array of PWM duty cycle values that correspond to > + linear volume levels. These need to be in the range of 0 to 500, > + while 0 means 0% duty cycle (mute) and 500 means 50% duty cycle > + (max volume). > + Please note that the actual volume of most beepers is highly > + non-linear, which means that low volume levels are probably somewhere > + in the range of 1 to 30 (0.1-3% duty cycle). > +- default-volume-level: the default volume level (index into the > + array defined by the "volume-levels" property) The bindings should be converted to DT schema first and then new properties added. Best regards, Krzysztof
