Re: [RFC PATCH 0/7] fix reset line polarity for Goodix touchscreen controllers

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Quentin,

On Thu, Nov 03, 2022 at 03:43:45PM +0100, Quentin Schulz wrote:
> The Goodix touchscreen controller has a reset line active low. It happens to
> also be used to configure its i2c address at runtime. If the reset line is
> incorrectly asserted, the address will be wrongly configured. This cost me a few
> hours yesterday, trying to figure out why the touchscreen wouldn't work.
> 
> The driver is "asserting" this reset GPIO by setting its output to 0, probably
> to reflect the physical state of the line. However, this relies on the fact that
> the Device Tree node setting the reset line polarity to active high, which is
> incorrect since the reset is active low in hardware.
> 
> To fix this inconsistency, the polarity is inverted to not confuse the user
> about the reset line polarity.
> 
> This is marked as RFC because it breaks DT compatibility and also the Google
> CoachZ device is the only one with an active low polarity for the reset GPIO
> in DT, so not sure if it is a typo or its state is actually inverted (so GPIO
> active high to drive the reset line low). Changing it anyways since the polarity
> is changed in the driver so it needs to be changed in DT too.

I would like to get gpio handling into a better shape, but the above is
completely incorrect. "goodix,gt7375p" that is used in CoachZ and other
Google designs is using i2c-hid compatible firmware and is not being
driven by drivers/input/touchscreen/goodix.c driver, but rather by
i2c-hid + hid-multitouch combo.

You should not be touching arch/arm64/boot/dts/qcom/sc7180* at all.

> 
> I'm all ears if there's a better way to handle this. We could document this in
> the DT binding but this kinda breaks the promise we make that the DT is not
> bound to the driver implementation.

I think Hans has already voiced concerns about x86 devices using these
devices and having GPIO data encoded in the driver, so we need to
accommodate them. On DT side we can add a quirk to gpiolib-of.c to
[maybe temporary] override polarity of reset GPIO lines, then update DTS
to match the reality.

Thanks.

-- 
Dmitry



[Index of Archives]     [Linux Media Devel]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Linux Wireless Networking]     [Linux Omap]

  Powered by Linux