This patch fixes interrupt trigger (should be level low as that is what the
driver is always using), the GPIO that is the interrupt source that is also
used to wake up chip by driving the line low.
The proper polarity is be needed for converting the driver to gpiod API.
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@xxxxxxxxx>
---
arch/arm/boot/dts/imx6qdl-sabreauto.dtsi | 4 ++--
arch/arm/boot/dts/imx6qdl-sabresd.dtsi | 8 ++++----
2 files changed, 6 insertions(+), 6 deletions(-)
diff --git a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
index 1368a4762037..1883350d004e 100644
--- a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
@@ -451,8 +451,8 @@ touchscreen@4 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_egalax_int>;
interrupt-parent = <&gpio2>;
- interrupts = <28 IRQ_TYPE_EDGE_FALLING>;
- wakeup-gpios = <&gpio2 28 GPIO_ACTIVE_HIGH>;
+ interrupts = <28 IRQ_TYPE_LEVEL_LOW>;
+ wakeup-gpios = <&gpio2 28 GPIO_ACTIVE_LOW>;
};
};
diff --git a/arch/arm/boot/dts/imx6qdl-sabresd.dtsi b/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
index 37482a9023fc..09f4c2fa3ad6 100644
--- a/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-sabresd.dtsi
@@ -311,8 +311,8 @@ touchscreen@4 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_i2c2_egalax_int>;
interrupt-parent = <&gpio6>;
- interrupts = <8 IRQ_TYPE_EDGE_FALLING>;
- wakeup-gpios = <&gpio6 8 GPIO_ACTIVE_HIGH>;
+ interrupts = <8 IRQ_TYPE_LEVEL_LOW>;
+ wakeup-gpios = <&gpio6 8 GPIO_ACTIVE_LOW>;
};
ov5640: camera@3c {
@@ -450,8 +450,8 @@ egalax_ts@4 {
compatible = "eeti,egalax_ts";
reg = <0x04>;
interrupt-parent = <&gpio6>;
- interrupts = <7 2>;
- wakeup-gpios = <&gpio6 7 0>;
+ interrupts = <7 IRQ_TYPE_LEVEL_LOW>;
+ wakeup-gpios = <&gpio6 7 GPIO_ACTIVE_LOW>;
};
magnetometer@e {
--
2.37.3.968.ga6b4b080e4-goog
