On Wed, 25 Aug 2021 17:25:05 +0200
Miquel Raynal <miquel.raynal@xxxxxxxxxxx> wrote:
> The datasheet states that most of the configuration should be set in the
> control register in the first place, before actually enabling the
> hardware.
Reference always good.
> So far only half of the configuration was made in the first
> step, which does not make really sense and would complicating the code
> when introducing support for the am437x hardware.
>
> Let's move that register write a bit below to enclose more configuration.
>
> Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Looks fine to me otherwise.
> ---
> drivers/mfd/ti_am335x_tscadc.c | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/mfd/ti_am335x_tscadc.c b/drivers/mfd/ti_am335x_tscadc.c
> index a40091830cea..1a30610dc65f 100644
> --- a/drivers/mfd/ti_am335x_tscadc.c
> +++ b/drivers/mfd/ti_am335x_tscadc.c
> @@ -224,7 +224,6 @@ static int ti_tscadc_probe(struct platform_device *pdev)
> tscadc->ctrl = CNTRLREG_STEPID;
> if (tscadc->data->has_tsc) {
> tscadc->ctrl |= CNTRLREG_TSC_STEPCONFIGWRT;
> - regmap_write(tscadc->regmap, REG_CTRL, tscadc->ctrl);
> if (use_tsc) {
> tscadc->ctrl |= CNTRLREG_TSC_ENB;
> if (tscmag_wires == 5)
> @@ -235,6 +234,8 @@ static int ti_tscadc_probe(struct platform_device *pdev)
>
> }
>
> + regmap_write(tscadc->regmap, REG_CTRL, tscadc->ctrl);
> +
> tscadc_idle_config(tscadc);
>
> /* Enable the TSC module enable bit */
