On Fri, Feb 19, 2021 at 12:05:56PM +0100, Michael Tretter wrote:
> The st1232 can switch from NORMAL to IDLE state after the configured
> idle time (by default 8 s). If the st1232 is not reset during probe, it
> might already be ready but in IDLE state. Since it does not enter NORMAL
> state in this case, probe fails.
>
> Fix the wait function to report the IDLE state as ready, too.
>
> Fixes: f605be6a57b4 ("Input: st1232 - wait until device is ready before reading resolution")
> Signed-off-by: Michael Tretter <m.tretter@xxxxxxxxxxxxxx>
Applied, thank you.
--
Dmitry
