Hi Rob,
Thank you for your review; agreed on all comments.
Should address your feedback in v2.
On Thu, Feb 04, 2021 at 08:39:01PM +0800, Joe Hung wrote:
> Add binding documentation for ILITEK touch devices.
Bindings are in DT schema format now. Please convert.
>
> Signed-off-by: Joe Hung <joe_hung@xxxxxxxxxx>
> ---
> .../input/touchscreen/ilitek_ts_i2c.txt | 23 +++++++++++++++++++
> 1 file changed, 23 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/input/touchscreen/ilitek_ts_i2c.txt
>
> diff --git a/Documentation/devicetree/bindings/input/touchscreen/ilitek_ts_i2c.txt b/Documentation/devicetree/bindings/input/touchscreen/ilitek_ts_i2c.txt
> new file mode 100644
> index 000000000000..eb90d3bd7ee7
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/input/touchscreen/ilitek_ts_i2c.txt
> @@ -0,0 +1,23 @@
> +Ilitek I2C 23XX/25XX/Lego Series Touch ICs
> +
> +Required properties:
> +- compatible : Must be equal to one of following:
> + "ilitek,ili2520"
> + "ilitek,ili2510"
> +- reg : I2C slave address for touch device.
> +- reset-gpios : GPIO output high to reset pin of touch device.
> +- irq-gpios : GPIO as active low input from touch irq pin.
Use 'interrupts' instead.
> +
> +Example:
> + &i2c1 {
> + /* ... */
> +
> + touchscreen@41 {
> + compatible = "ilitek,ili2520";
> + reg = <0x41>;
> + irq-gpios = <&gpio1 13 0>;
> + reset-gpios = <&gpio1 14 GPIO_ACTIVE_HIGH>;
> + };
> +
> + /* ... */
> + };
> --
> 2.25.1
>
>
