Hi Bastien, >Given that we do have access to the datasheet, it would also be useful >for the patch to mention where in the datasheet it says that the reset >line can be left pulled-up, The pin description table on section 4, on the "Reset pin" row, contains a remark as follows: External 10K pull-up resistor required, active-low reset This comes from a newer revision of the datasheet though: http://focuslcds.com/content/GT911.pdf I guess it's open to interpretation whether driving the reset line is optional. The code seemed to imply it by using devm_gpiod_get_optional() to obtain the GPIO. >or mention on which shipping device this >setup is already used (and if so, what the DTS or ACPI snippet that >declares those is). > I am testing with an LCD application kit for the ConnectCore 6UL SBC Pro: https://www.digi.com/products/models/cc-acc-lcdw-10 https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/arch/arm/boot/dts/imx6ul-ccimx6ulsbcpro.dts?h=v5.0-rc1#n120 This display in particular does not have the reset line available on the connector. The only way to make it work seems to be to use the INT line to fix an I2C address. >Cheers >
