On Thu, Sep 28, 2017 at 05:23:17PM +0200, Ahmet Inan wrote:
> The 3000 series have a new protocol which allows to report up to 5 points
> in a single 66 byte frame. One must always read in 66 byte frames.
> To support up to 10 points, two consecutive frames need to be read:
> The first frame says how many points until sync.
> The second frame must say zero points or both frames must be discarded.
>
> To be able to work with the higher 400KHz I2C bus rate, one must
> successfully send a special package prior _each_ read or the controller
> will refuse to cooperate.
>
> This is a minimal implementation based on egalax_i2c.c (which can be found
> on the internet) and egalax_ts.c but without the vendor interface and no
> power management support.
>
> Signed-off-by: Ahmet Inan <inan@xxxxxxxxx>
> ---
> .../bindings/input/touchscreen/exc3000.txt | 27 ++++
Please split to separate patch.
> drivers/input/touchscreen/Kconfig | 10 ++
> drivers/input/touchscreen/Makefile | 1 +
> drivers/input/touchscreen/exc3000.c | 173 +++++++++++++++++++++
> 4 files changed, 211 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/input/touchscreen/exc3000.txt
> create mode 100644 drivers/input/touchscreen/exc3000.c
>
> diff --git a/Documentation/devicetree/bindings/input/touchscreen/exc3000.txt b/Documentation/devicetree/bindings/input/touchscreen/exc3000.txt
> new file mode 100644
> index 000000000000..d2a78e83e921
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/input/touchscreen/exc3000.txt
> @@ -0,0 +1,27 @@
> +* EETI EXC3000 Multiple Touch Controller
> +
> +Required properties:
> +- compatible: must be "eeti,exc3000"
> +- reg: i2c slave address
> +- interrupt-parent: the phandle for the interrupt controller
> +- interrupts: touch controller interrupt
> +- touchscreen-size-x: See touchscreen.txt
> +- touchscreen-size-y: See touchscreen.txt
> +
> +Optional properties:
> +- touchscreen-inverted-x: See touchscreen.txt
> +- touchscreen-inverted-y: See touchscreen.txt
> +- touchscreen-swapped-x-y: See touchscreen.txt
> +
> +Example:
> +
> + exc3000@2a {
touchscreen@2a
> + compatible = "eeti,exc3000";
> + reg = <0x2a>;
> + interrupt-parent = <&gpio1>;
> + interrupts = <9 8>; // active low level-sensitive
Use the defines for flags.
> + touchscreen-size-x = <4096>;
> + touchscreen-size-y = <4096>;
> + touchscreen-inverted-x;
> + touchscreen-swapped-x-y;
> + };
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
