Re: [PATCH] Input: egalax_ts - do not release gpio if probe successful

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Gary,

On Wed, Jan 11, 2017 at 06:28:41PM +0100, Gary Bisson wrote:
> Thus preventing anyone to later modify the interrupt GPIO direction
> and/or state without the driver knowing.

I am afraid not releasing gpio after waking up the controller will cause
request_irq to fail if we are using the same pin for interrupt and
wakeup (as majority of current DTSes do: see
arch/arm/boot/dts/imx53-tx53-x13x.dts for example).

You'll need to figure out if irq is backed by the same gpio as wakeup
and act accordingly.

What setup did you test this on? Was it shared pin or dedicated wakeup?

Thanks.

> 
> Also checking if device is present before allocating the input device.
> 
> Signed-off-by: Gary Bisson <gary.bisson@xxxxxxxxxxxxxxxxxxx>
> ---
>  drivers/input/touchscreen/egalax_ts.c | 56 ++++++++++++++++-------------------
>  1 file changed, 25 insertions(+), 31 deletions(-)
> 
> diff --git a/drivers/input/touchscreen/egalax_ts.c b/drivers/input/touchscreen/egalax_ts.c
> index 1afc08b08155..f6b94bb19bd8 100644
> --- a/drivers/input/touchscreen/egalax_ts.c
> +++ b/drivers/input/touchscreen/egalax_ts.c
> @@ -62,6 +62,7 @@
>  struct egalax_ts {
>  	struct i2c_client		*client;
>  	struct input_dev		*input_dev;
> +	struct gpio_desc		*wakeup_gpio;
>  };
>  
>  static irqreturn_t egalax_ts_interrupt(int irq, void *dev_id)
> @@ -120,36 +121,21 @@ static irqreturn_t egalax_ts_interrupt(int irq, void *dev_id)
>  }
>  
>  /* wake up controller by an falling edge of interrupt gpio.  */
> -static int egalax_wake_up_device(struct i2c_client *client)
> +static int egalax_wake_up_device(struct gpio_desc *wakeup_gpio)
>  {
> -	struct device_node *np = client->dev.of_node;
> -	int gpio;
>  	int ret;
>  
> -	if (!np)
> -		return -ENODEV;
> -
> -	gpio = of_get_named_gpio(np, "wakeup-gpios", 0);
> -	if (!gpio_is_valid(gpio))
> -		return -ENODEV;
> -
> -	ret = gpio_request(gpio, "egalax_irq");
> -	if (ret < 0) {
> -		dev_err(&client->dev,
> -			"request gpio failed, cannot wake up controller: %d\n",
> -			ret);
> +	/* wake up controller via an falling edge on IRQ gpio. */
> +	ret = gpiod_direction_output(wakeup_gpio, 0);
> +	if (ret < 0)
>  		return ret;
> -	}
>  
> -	/* wake up controller via an falling edge on IRQ gpio. */
> -	gpio_direction_output(gpio, 0);
> -	gpio_set_value(gpio, 1);
> +	gpiod_set_value(wakeup_gpio, 1);
>  
>  	/* controller should be waken up, return irq.  */
> -	gpio_direction_input(gpio);
> -	gpio_free(gpio);
> +	ret = gpiod_direction_input(wakeup_gpio);
>  
> -	return 0;
> +	return ret;
>  }
>  
>  static int egalax_firmware_version(struct i2c_client *client)
> @@ -177,17 +163,15 @@ static int egalax_ts_probe(struct i2c_client *client,
>  		return -ENOMEM;
>  	}
>  
> -	input_dev = devm_input_allocate_device(&client->dev);
> -	if (!input_dev) {
> -		dev_err(&client->dev, "Failed to allocate memory\n");
> -		return -ENOMEM;
> +	ts->wakeup_gpio = devm_gpiod_get_index(&client->dev, "wakeup",
> +					       0, GPIOD_ASIS);
> +	if (IS_ERR(ts->wakeup_gpio)) {
> +		dev_err(&client->dev, "Failed to get wakeup gpio");
> +		return -ENODEV;
>  	}
>  
> -	ts->client = client;
> -	ts->input_dev = input_dev;
> -
>  	/* controller may be in sleep, wake it up. */
> -	error = egalax_wake_up_device(client);
> +	error = egalax_wake_up_device(ts->wakeup_gpio);
>  	if (error) {
>  		dev_err(&client->dev, "Failed to wake up the controller\n");
>  		return error;
> @@ -199,6 +183,15 @@ static int egalax_ts_probe(struct i2c_client *client,
>  		return error;
>  	}
>  
> +	input_dev = devm_input_allocate_device(&client->dev);
> +	if (!input_dev) {
> +		dev_err(&client->dev, "Failed to allocate memory\n");
> +		return -ENOMEM;
> +	}
> +
> +	ts->client = client;
> +	ts->input_dev = input_dev;
> +
>  	input_dev->name = "EETI eGalax Touch Screen";
>  	input_dev->id.bustype = BUS_I2C;
>  
> @@ -254,8 +247,9 @@ static int __maybe_unused egalax_ts_suspend(struct device *dev)
>  static int __maybe_unused egalax_ts_resume(struct device *dev)
>  {
>  	struct i2c_client *client = to_i2c_client(dev);
> +	struct egalax_ts *ts = i2c_get_clientdata(client);
>  
> -	return egalax_wake_up_device(client);
> +	return egalax_wake_up_device(ts->wakeup_gpio);
>  }
>  
>  static SIMPLE_DEV_PM_OPS(egalax_ts_pm_ops, egalax_ts_suspend, egalax_ts_resume);
> -- 
> 2.11.0
> 

-- 
Dmitry
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html



[Index of Archives]     [Linux Media Devel]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Linux Wireless Networking]     [Linux Omap]

  Powered by Linux