Make the avarage-samples property a general touchscreen property
rather than imx6ul device specific.
Signed-off-by: Guy Shapiro <guy.shapiro@xxxxxxxxxxxxx>
---
.../bindings/input/touchscreen/imx6ul_tsc.txt | 11 ++----
.../bindings/input/touchscreen/touchscreen.txt | 3 ++
drivers/input/touchscreen/imx6ul_tsc.c | 46 ++++++++++++++++------
3 files changed, 41 insertions(+), 19 deletions(-)
diff --git a/Documentation/devicetree/bindings/input/touchscreen/imx6ul_tsc.txt b/Documentation/devicetree/bindings/input/touchscreen/imx6ul_tsc.txt
index a66069f..d4927c2 100644
--- a/Documentation/devicetree/bindings/input/touchscreen/imx6ul_tsc.txt
+++ b/Documentation/devicetree/bindings/input/touchscreen/imx6ul_tsc.txt
@@ -17,13 +17,8 @@ Optional properties:
This value depends on the touch screen.
- pre-charge-time: the touch screen need some time to precharge.
This value depends on the touch screen.
-- average-samples: Number of data samples which are averaged for each read.
- Valid values 0-4
- 0 = 1 sample
- 1 = 4 samples
- 2 = 8 samples
- 3 = 16 samples
- 4 = 32 samples
+- touchscreen-average-samples: Number of data samples which are averaged for
+ each read. Valid values are 1, 4, 8, 16 and 32.
Example:
tsc: tsc@02040000 {
@@ -39,6 +34,6 @@ Example:
xnur-gpio = <&gpio1 3 GPIO_ACTIVE_LOW>;
measure-delay-time = <0xfff>;
pre-charge-time = <0xffff>;
- average-samples = <4>;
+ touchscreen-average-samples = <32>;
status = "okay";
};
diff --git a/Documentation/devicetree/bindings/input/touchscreen/touchscreen.txt b/Documentation/devicetree/bindings/input/touchscreen/touchscreen.txt
index bccaa4e..537643e 100644
--- a/Documentation/devicetree/bindings/input/touchscreen/touchscreen.txt
+++ b/Documentation/devicetree/bindings/input/touchscreen/touchscreen.txt
@@ -14,6 +14,9 @@ Optional properties for Touchscreens:
- touchscreen-fuzz-pressure : pressure noise value of the absolute input
device (arbitrary range dependent on the
controller)
+ - touchscreen-average-samples : Number of data samples which are averaged
+ for each read (valid values dependent on the
+ controller)
- touchscreen-inverted-x : X axis is inverted (boolean)
- touchscreen-inverted-y : Y axis is inverted (boolean)
- touchscreen-swapped-x-y : X and Y axis are swapped (boolean)
diff --git a/drivers/input/touchscreen/imx6ul_tsc.c b/drivers/input/touchscreen/imx6ul_tsc.c
index d2a3912..58d1aa5 100644
--- a/drivers/input/touchscreen/imx6ul_tsc.c
+++ b/drivers/input/touchscreen/imx6ul_tsc.c
@@ -93,7 +93,8 @@ struct imx6ul_tsc {
u32 measure_delay_time;
u32 pre_charge_time;
- u32 average_samples;
+ bool average_enable;
+ u32 average_select;
struct completion completion;
};
@@ -117,9 +118,9 @@ static int imx6ul_adc_init(struct imx6ul_tsc *tsc)
adc_cfg |= ADC_12BIT_MODE | ADC_IPG_CLK;
adc_cfg &= ~(ADC_CLK_DIV_MASK | ADC_SAMPLE_MODE_MASK);
adc_cfg |= ADC_CLK_DIV_8 | ADC_SHORT_SAMPLE_MODE;
- if (tsc->average_samples) {
+ if (tsc->average_enable) {
adc_cfg &= ~ADC_AVGS_MASK;
- adc_cfg |= (tsc->average_samples - 1) << ADC_AVGS_SHIFT;
+ adc_cfg |= (tsc->average_select) << ADC_AVGS_SHIFT;
}
adc_cfg &= ~ADC_HARDWARE_TRIGGER;
writel(adc_cfg, tsc->adc_regs + REG_ADC_CFG);
@@ -132,7 +133,7 @@ static int imx6ul_adc_init(struct imx6ul_tsc *tsc)
/* start ADC calibration */
adc_gc = readl(tsc->adc_regs + REG_ADC_GC);
adc_gc |= ADC_CAL;
- if (tsc->average_samples)
+ if (tsc->average_enable)
adc_gc |= ADC_AVGE;
writel(adc_gc, tsc->adc_regs + REG_ADC_GC);
@@ -362,6 +363,7 @@ static int imx6ul_tsc_probe(struct platform_device *pdev)
int err;
int tsc_irq;
int adc_irq;
+ u32 average_samples;
tsc = devm_kzalloc(&pdev->dev, sizeof(*tsc), GFP_KERNEL);
if (!tsc)
@@ -466,14 +468,36 @@ static int imx6ul_tsc_probe(struct platform_device *pdev)
if (err)
tsc->pre_charge_time = 0xfff;
- err = of_property_read_u32(np, "average-samples",
- &tsc->average_samples);
+ err = of_property_read_u32(np, "touchscreen-average-samples",
+ &average_samples);
if (err)
- tsc->average_samples = 0;
-
- if (tsc->average_samples > 4) {
- dev_err(&pdev->dev, "average-samples (%u) must be [0-4]\n",
- tsc->average_samples);
+ average_samples = 1;
+
+ switch (average_samples) {
+ case 1:
+ tsc->average_enable = false;
+ tsc->average_select = 0; /* value unused; initialize anyway */
+ break;
+ case 4:
+ tsc->average_enable = true;
+ tsc->average_select = 0;
+ break;
+ case 8:
+ tsc->average_enable = true;
+ tsc->average_select = 1;
+ break;
+ case 16:
+ tsc->average_enable = true;
+ tsc->average_select = 2;
+ break;
+ case 32:
+ tsc->average_enable = true;
+ tsc->average_select = 3;
+ break;
+ default:
+ dev_err(&pdev->dev,
+ "touchscreen-average-samples (%u) must be 1, 4, 8, 16 or 32\n",
+ average_samples);
return -EINVAL;
}
--
2.1.4
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
