> On Thu, Oct 27, 2016 at 4:19 PM, Dmitry Torokhov > <dmitry.torokhov@xxxxxxxxx> wrote: > > On Thu, Oct 27, 2016 at 02:31:13PM -0700, Roderick Colenbrander wrote: > >> From: Roderick Colenbrander <roderick.colenbrander@xxxxxxxx> > >> > >> The input-mt driver pointer emulation from 'input_mt_sync_frame' regardless > >> of the flags passed in to 'input_mt_init_slots' by device drivers. > > > > Right, because needing single-touch (pointer) emulation is not property > > of device or driver but rather consumer. If we get to the point where > > everything is ready to accept multi-touch (are we there yet) then we can > > stop doing pointer emulation altogether. > > > >> > >> Pointer emulation is undesired on drivers, which didn't request this > >> capability like the hid-sony driver for the Dualshock 4. This gamepad already > >> reports ABS_X / ABS_Y for gamepad stick purposes. Pointer emulation would > >> inject touchpad values into these sticks, which is undesired. > > > > The driver should not be re-purposing events like that. > > ABS_MT_POSITION_X and ABS_X should match. > > > > Why doesn't driver follow Documentation/input/gamepad.txt? > > > > The original hid-sony code and the multitouch handling code for the Dualshock 4 > were written by the community. We are stepping in to make the hid-sony driver > properly handle the Dualshock 4. > The driver doesn't fully follow the gamepad spec yet, which we will > try to improve. At > least the left analog stick is reported as ABS_X and ABS_Y already, > but the buttons > are inconsistent and right stick is wrong as well. > While it would be great to conform to the spec, the conflict with > multitouch would still > exist as the Dualshock 4 has both analog sticks and a multitouch touchpad. The button and axis mappings are what the controller’s default HID descriptor provides. The descriptors in the driver just extend the ones sent by the controller to allow additional functionality(i.e. gyro/accel and full Bluetooth mode), but the button and axis mappings were unchanged from the defaults so as not to introduce mapping discrepencies with older kernels which used the generic HID driver. Note that changing them at this point *will* break a lot of software (SDL has had these mappings hardcoded into it’s controller database header for years now). > > Disabling the pointer emulation feature avoids the conflict. This > issue was only exposed > recently by adding of the input_mt_sync_frame call as recommended by Benjamin as > part of some improvements we did for touchpad handling in hid-sony. > Is input_mt_sync_frame even necessary? The original implementation followed the protocol for a “Type B” device as defined in Documentation/input/multi-touch-protocol.txt which doesn’t require SYN_MT_REPORT messages.-- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
