On Sat, 2016-09-10 at 20:57 +0300, Irina Tirdea wrote: > According to the Goodix datasheet, the reset sequence will leave > the reset line set to output high. To end the selection of the I2C > address, we just need to set the input line to low for at least > 50 ms and then set it to input floating (already implemented by > goodix_int_sync). > > Remove setting the reset line to input from the reset sequence, > since that is not reflected in the datasheet. > > This is based on Goodix datasheets for GT911 and GT9271 and on Goodix > driver gt9xx.c for Android (publicly available in Android kernel > trees for various devices). > > Suggested-by: Troy Kisky <troy.kisky@xxxxxxxxxxxxxxxxxxx> > Signed-off-by: Irina Tirdea <irina.tirdea@xxxxxxxxx> Code looks fine. Again, would be nice to know on which devices this was tested. > --- > drivers/input/touchscreen/goodix.c | 4 ---- > 1 file changed, 4 deletions(-) > > diff --git a/drivers/input/touchscreen/goodix.c > b/drivers/input/touchscreen/goodix.c > index 182ff9c..6fba804 100644 > --- a/drivers/input/touchscreen/goodix.c > +++ b/drivers/input/touchscreen/goodix.c > @@ -454,10 +454,6 @@ static int goodix_reset(struct goodix_ts_data > *ts) > usleep_range(6000, 10000); /* T4: > 5ms */ > > /* end select I2C slave addr */ > - error = gpiod_direction_input(ts->gpiod_rst); > - if (error) > - return error; > - > error = goodix_int_sync(ts); > if (error) > return error; -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
