From: Even Xu <even.xu@xxxxxxxxx>
When built as a module, modprobe followed by rmmod can fail because
DMA was still active. So to fix this, DMA needs to be disabled during
module exit.
This change disables DMA during modules exit and change the ISH PCI
device status to D3.
Signed-off-by: Even Xu <even.xu@xxxxxxxxx>
Acked-by: Srinivas Pandruvada <srinivas.pandruvada@xxxxxxxxxxxxxxx>
---
drivers/hid/intel-ish-hid/ipc/ipc.c | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/drivers/hid/intel-ish-hid/ipc/ipc.c b/drivers/hid/intel-ish-hid/ipc/ipc.c
index 0e0dfa6..66c6755 100644
--- a/drivers/hid/intel-ish-hid/ipc/ipc.c
+++ b/drivers/hid/intel-ish-hid/ipc/ipc.c
@@ -905,6 +905,26 @@ struct ishtp_device *ish_dev_init(struct pci_dev *pdev)
*/
void ish_device_disable(struct ishtp_device *dev)
{
+ struct pci_dev *pdev = dev->pdev;
+ uint16_t csr;
+
+ if (!pdev)
+ return;
+
+ /* Disable dma communication between FW and host */
+ if (ish_disable_dma(dev)) {
+ dev_err(&pdev->dev,
+ "Can't reset - stuck with DMA in-progress\n");
+ return;
+ }
+
+ /* Put ISH to D3 state for power saving */
+ pci_read_config_word(pdev, pdev->pm_cap + PCI_PM_CTRL, &csr);
+
+ csr &= ~PCI_PM_CTRL_STATE_MASK;
+ csr |= PCI_D3hot;
+ pci_write_config_word(pdev, pdev->pm_cap + PCI_PM_CTRL, csr);
+
dev->dev_state = ISHTP_DEV_DISABLED;
ish_clr_host_rdy(dev);
}
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
