On May 17 2016 or thereabouts, Dmitry Torokhov wrote: > Hi Benjamin, > > On Tue, May 17, 2016 at 12:16:19PM +0200, Benjamin Tissoires wrote: > > This is a basic driver for the Surface 3. I am not so sure it will work > > with any firmwares as most values are encoded, but given that I only have > > access to my current device with its firmware and I don't have the > > datasheet, it should be OK for now. > > > > The Surface Pen is not supported (if it is supposed to be). I'll work on > > this when I get one. > > > > Signed-off-by: Benjamin Tissoires <benjamin.tissoires@xxxxxxxxxx> > > --- > > Changes in v2: > > > > - module renamed from ntrig_spi to surface3_spi > > - took into account Dmitry's remarks > > - kept the retrieval of the GPIO as mandatory as otherwise the device fails to work > > > > Changes in v3: > > > > - asm include put at the end > > - used proper types in struct surfacae3_ts_data_finger > > - dropped temps in surface3_spi_report_touch() > > - inlined surface3_spi_request_irq() > > - detect IRQ type (falling/rising) depending on the gpiod active low parameter > > I do not think that this should be done in the driver. The device either > has interrupt descriptor or GpioInt decriptor in DSDT and SPI core/ACPI > should do the right thing and configure GPIO as input and set interrupt > polarity accordingly, so when you do request_threaded_irq() you only > need to specify IRQF_ONESHOT. > > See drivers/spi/spi.c - in case there is no interrupt specified we call > acpi_dev_gpio_irq_get(). Do you see it called in your case? Or your DSDT > has interrupt for the touchscreen device and acpi_spi_add_resource() and > acpi_dev_resource_interrupt() are called? You need to trace it and > figure out if there is an issue there with setting up interrupt > properly. Looks like I need to push further the tests. From what I can see, using just IRQF_ONESHOT is not sufficient enough and I need to add the trigger falling manually (thus this way of doing). I'll keep digging. Cheers, Benjamin -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
