On Tue, Mar 08, 2016 at 03:03:23PM -0800, Dmitry Torokhov wrote: > On ACPI-based systems ACPI power domain code runtime resumes device before > calling suspend method, which ensures that i2c-hid suspend code starts with > device not in low-power state and with interrupts enabled. > > On other systems, especially if device is not a part of any power domain, > we may end up calling driver's system-level suspend routine while the > device is runtime-suspended (with controller in presumably low power state > and interrupts disabled). This will result in interrupts being essentially > disabled twice, and we will only re-enable them after both system resume > and runtime resume methods complete. Unfortunately i2c_hid_resume() calls > i2c_hid_hwreset() and that only works properly if interrupts are enabled. > > Also if device is runtime-suspended driver's suspend code may fail if it > tries to issue I/O requests. > > Let's fix it by runtime-resuming the device if we need to run HID driver's > suspend code and also disabling interrupts only if device is not already > runtime-suspended. Also on resume we mark the device as running at full > power (since that is what resetting will do to it). > > Signed-off-by: Doug Anderson <dianders@xxxxxxxxxxxx> > Signed-off-by: Dmitry Torokhov <dtor@xxxxxxxxxxxx> Tested on a couple of Intel Skylake and Baytrail based systems and power management of I2C connected HID devices still seems to work just fine. Tested-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx> -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
