Hi, This is v2 of the cpufreq support series for sunxi. The series has been rebased onto the latest sunxi-next. I've dropped all the patches Maxime merged. This includes "ARM: sunxi: Register cpufreq-dt for sun[45678]i" which was merged but not published yet. Individual changes since v1 are listed within each patch. Original cover letter follows: This series adds support cpufreq support for sun[457]i using cpufreq-dt. This also supports passive cpu cooling (thermal throttling) using thermal zones with the temperature sensor in the SoC. The operating points for the supported platforms were taken from the linux-sunxi FEX files repository. The majority of boards use the same settings. Only with sun7i do we see slight variations, either disabling some frequencies, or bumping up the voltage a bit. In either case this can be done by limiting the constraints for the supply regulator, or overriding the OPP table in the board dts file. On sun7i, there is an additional operating point not found in the FEX files, 960 MHz @ 1.4V, which is the full speed setting in both u-boot-sunxi and mainline u-boot. The series has been tested on the 4 boards I have. With cpufreq active, the effects are visible as a decrease in SoC internal temperature. Stability for the operating points has been tested using: http://linux-sunxi.org/Hardware_Reliability_Tests#Reliability_of_cpufreq_voltage.2Ffrequency_settings More real world usage feedback is appreciated. Thermal throttling hasn't been tested much, due to not being able to generate enough load without the GPU for the SoC to heat up. Also on sun4i, the temperature sensor still hasn't been calibrated, so the readings are highly inaccurate. Chen-Yu Tsai (9): Input: sun4i-ts: Add thermal zone sensor support ARM: dts: sunxi: Add dtsi for AXP209 PMIC ARM: dts: sun7i: Add cpu thermal zones to dtsi ARM: dts: sun7i: cubieboard2: add axp209 regulator nodes ARM: dts: sun7i: cubietruck: add axp209 regulator nodes ARM: dts: sun5i: Add cpu thermal zones to dtsi ARM: dts: sun5i: hsg-h702: add axp209 regulator nodes ARM: dts: sun4i: Add cpu thermal zones to dtsi ARM: dts: sun4i: cubieboard: add axp209 regulator nodes .../bindings/input/touchscreen/sun4i.txt | 2 + arch/arm/boot/dts/axp209.dtsi | 97 ++++++++++++++++++++++ arch/arm/boot/dts/sun4i-a10-cubieboard.dts | 35 +++++++- arch/arm/boot/dts/sun4i-a10.dtsi | 34 ++++++++ arch/arm/boot/dts/sun5i-a13-hsg-h702.dts | 46 ++++++++-- arch/arm/boot/dts/sun5i-a13.dtsi | 34 ++++++++ arch/arm/boot/dts/sun7i-a20-cubieboard2.dts | 35 +++++++- arch/arm/boot/dts/sun7i-a20-cubietruck.dts | 35 +++++++- arch/arm/boot/dts/sun7i-a20.dtsi | 33 ++++++++ drivers/input/touchscreen/sun4i-ts.c | 47 +++++++++++ 10 files changed, 378 insertions(+), 20 deletions(-) create mode 100644 arch/arm/boot/dts/axp209.dtsi -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
