This set consists of one bugfix, two mostly cosmetic changes and three larger patches for the LED subsystem. Patch #4 adds hardware blink support to the controller LEDs. Values from 0 to 2.5 seconds are supported by the hardware. The Sixaxis can set all of the LEDs individually, but the DualShock 4 only has one global setting for the entire light bar so only the value from the most recently set LED is used. Patch #5 adds an LED trigger that reports the controller battery status via the registered LEDs. The LEDs will flash if the controller is charging or if the battery is low, and remain solid otherwise. Patch #6 initializes the LEDs to a default value of LED 1 on the Sixaxis and blue on the DualShock 4 so there is some indication that the controller is powered on and connected in the case of Bluetooth. The code can be used to set the LEDs based on the device number, but I'm not sure how to actually retrieve the controller number from the system. I saw the xpad patches posted a few weeks ago where the minor number of the joydev device was used, but I'm under the impression that doing that is not ideal. Any suggestions? -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
