On Thursday 19 January 2012 01:09 PM, Laxman Dewangan wrote:
On Thursday, January 19, 2012 1:00 PM, Dmitry Torokhov wrote:
On Tue, Jan 17, 2012 at 11:11:55AM +0530, Laxman Dewangan wrote:
This driver enables the key detection of the keys which
are connected to interrupt lines.
Each key is capable of generating an interrupt, and the
statesi (pressed or released) cannot be found by any
mechanism.
A key press event generated when interrupt occurs, and
based on the debounce time setting, a key release event
is generated. There is no need to read the state of the
keys.
Is it possible to modify gpio_keys to skip requesting and settin up
certain gpios and and use it instead of a brand new driver?
I first tried this approach and found that this makes the gpio_keys
driver very complex because almost all places where gpio-apis are
getting called need to put under if condition.
Also there is some special handling for auto key release events
Which makes gpio-key driver again complex.
Hi Dmitry,
Do you have any further comment on above approach? Here is little bit
background which can help on understanding.
I am working on some MFD devices and to tried to support the onkey from
single driver to avoid having driver for each mfd-pmic driver.
When developing this driver, I though of following behaviors of the pmic
device for power-btn/onkey switches:
1. Separate Interrupt for press and release: (Falling and rising
interrupt, no level interrupt) So two different interrupt will get
registered and based on interrupt number the key code and key value will
get reported to input system. Device like AB8500 (ab8500-ponkey.c).
2. Generates interrupt for only key press, no interrupt for the key
release (only one interrupt i.e. Falling edge) In this case, it need to
send the release event automatically after sending press event. So
whenever there is falling edge on keys, the interrupt get generated, No
interrupt on pressed level. Devices like ricoh583, max77663.
3. Keep generating interrupt if key is pressed but no interrupt after
release (Kind on level (low) interrupt and so multiple interrupts till
key pressed.) Devices like tps65910..
In this case, the device generates level interrupt and if it acked,
again generates interrupt. So if we send the key press/release together
without waiting, we will endup with sending the key event multiple time.
To avoid this I used the debaince logic as follows:
detect first interrupt, send press event and start timer and wait for
timer to expire for sending release events. If interrupt again occurs
before timer expires, restart timer again. Keep doing this until user
release the key. Once he release the key, there will be no interrupt and
so timer will be expire after some time i.e. debounce time and then
report key released.
--
Dmitry
--
To unsubscribe from this list: send the line "unsubscribe linux-input" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
