On Thu, Aug 18, 2011 at 08:58:53AM -0500, Seth Forshee wrote:
The case 3 code is nearly identical to case 2. How about this?
case 2:
__set_bit(BTN_TOOL_QUADTAP, dev->keybit);
/* fall through */
case 3:
input_set_abs_params(dev, ABS_X, x_min, x_max, 0, 0);
input_set_abs_params(dev, ABS_Y, y_min, y_max, 0, 0);
/* range of pressure and width is the same as v2 */
input_set_abs_params(dev, ABS_PRESSURE, ETP_PMIN_V2,
ETP_PMAX_V2, 0, 0);
input_set_abs_params(dev, ABS_TOOL_WIDTH, ETP_WMIN_V2,
ETP_WMAX_V2, 0, 0);
__set_bit(INPUT_PROP_SEMI_MT, dev->propbit);
input_mt_init_slots(dev, 2);
input_set_abs_params(dev, ABS_MT_POSITION_X, x_min, x_max, 0, 0);
input_set_abs_params(dev, ABS_MT_POSITION_Y, y_min, y_max, 0, 0);
break;
Sorry, that should have been:
case 2:
__set_bit(BTN_TOOL_QUADTAP, dev->keybit);
/* fall through */
case 3:
input_set_abs_params(dev, ABS_X, x_min, x_max, 0, 0);
input_set_abs_params(dev, ABS_Y, y_min, y_max, 0, 0);
if (etd->reports_pressure) {
input_set_abs_params(dev, ABS_PRESSURE, ETP_PMIN_V2,
ETP_PMAX_V2, 0, 0);
input_set_abs_params(dev, ABS_TOOL_WIDTH, ETP_WMIN_V2,
ETP_WMAX_V2, 0, 0);
}
__set_bit(INPUT_PROP_SEMI_MT, dev->propbit);
input_mt_init_slots(dev, 2);
input_set_abs_params(dev, ABS_MT_POSITION_X, x_min, x_max, 0, 0);
input_set_abs_params(dev, ABS_MT_POSITION_Y, y_min, y_max, 0, 0);
break;
