On Thu, Feb 3, 2011 at 10:49 PM, Dmitry Torokhov <dmitry.torokhov@xxxxxxxxx> wrote: > On Thu, Feb 03, 2011 at 08:54:05AM -0800, Dmitry Torokhov wrote: >> On Thu, Feb 03, 2011 at 08:51:46PM +0530, Sourav Poddar wrote: >> > The ads7846 driver requests a gpio but does not currently >> > configure it explicitly as an input. Use gpio_request_one >> > to request and configure it at one shot. >> > >> > Signed-off-by: Sourav Poddar <sourav.poddar@xxxxxx> >> > Cc: Dmitry Torokhov <dtor@xxxxxxx> >> >> Will apply this one, the other one is a bit messy IMO, will have to >> think about it. >> > > Something like below should do I think. > > -- > Dmitry > > > Input: ads7846 - check proper condition when freeing gpio > > From: Dmitry Torokhov <dmitry.torokhov@xxxxxxxxx> > > When driver uses custom pendown detection method gpio_pendown is not > set up and so we should not try to free it, otherwise we are presented > with: > > ------------[ cut here ]------------ > WARNING: at drivers/gpio/gpiolib.c:1258 gpio_free+0x100/0x12c() > Modules linked in: > [<c0061208>] (unwind_backtrace+0x0/0xe4) from [<c0091f58>](warn_slowpath_common+0x4c/0x64) > [<c0091f58>] (warn_slowpath_common+0x4c/0x64) from [<c0091f88>](warn_slowpath_null+0x18/0x1c) > [<c0091f88>] (warn_slowpath_null+0x18/0x1c) from [<c024e610>](gpio_free+0x100/0x12c) > [<c024e610>] (gpio_free+0x100/0x12c) from [<c03e9fbc>](ads7846_probe+0xa38/0xc5c) > [<c03e9fbc>] (ads7846_probe+0xa38/0xc5c) from [<c02cff14>](spi_drv_probe+0x18/0x1c) > [<c02cff14>] (spi_drv_probe+0x18/0x1c) from [<c028bca4>](driver_probe_device+0xc8/0x184) > [<c028bca4>] (driver_probe_device+0xc8/0x184) from [<c028bdc8>](__driver_attach+0x68/0x8c) > [<c028bdc8>] (__driver_attach+0x68/0x8c) from [<c028b4c8>](bus_for_each_dev+0x48/0x74) > [<c028b4c8>] (bus_for_each_dev+0x48/0x74) from [<c028ae08>](bus_add_driver+0xa0/0x220) > [<c028ae08>] (bus_add_driver+0xa0/0x220) from [<c028c0c0>](driver_register+0xa8/0x134) > [<c028c0c0>] (driver_register+0xa8/0x134) from [<c0050550>](do_one_initcall+0xcc/0x1a4) > [<c0050550>] (do_one_initcall+0xcc/0x1a4) from [<c00084e4>](kernel_init+0x14c/0x214) > [<c00084e4>] (kernel_init+0x14c/0x214) from [<c005b494>](kernel_thread_exit+0x0/0x8) > ---[ end trace 4053287f8a5ec18f ]--- > > Also rearrange ads7846_setup_pendown() to have only one exit point > returning success. > > Reported-by: Sourav Poddar <sourav.poddar@xxxxxx> > Signed-off-by: Dmitry Torokhov <dtor@xxxxxxx> > --- Acked-by: Sourav Poddar <sourav.poddar@xxxxxx> -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
