On Thu, 2010-07-29 at 19:26 +0300, Maxim Levitsky wrote: > On Thu, 2010-07-29 at 11:38 -0400, Andy Walls wrote: > > On Thu, 2010-07-29 at 17:41 +0300, Maxim Levitsky wrote: > > > On Thu, 2010-07-29 at 09:23 +0200, Christoph Bartelmus wrote: > > > > Hi Maxim, > > > > > > > > on 29 Jul 10 at 02:40, Maxim Levitsky wrote: > > > > [...] > > > > > In addition to comments, I changed helper function that processes samples > > > > > so it sends last space as soon as timeout is reached. > > > > > This breaks somewhat lirc, because now it gets 2 spaces in row. > > > > > However, if it uses timeout reports (which are now fully supported) > > > > > it will get such report in middle. > > > > > > > > > > Note that I send timeout report with zero value. > > > > > I don't think that this value is importaint. > > > > > > > > This does not sound good. Of course the value is important to userspace > > > > and 2 spaces in a row will break decoding. > > > > > > > > Christoph > > > > > > Could you explain exactly how timeout reports work? > > > > > > Lirc interface isn't set to stone, so how about a reasonable compromise. > > > After reasonable long period of inactivity (200 ms for example), space > > > is sent, and then next report starts with a pulse. > > > So gaps between keypresses will be maximum of 200 ms, and as a bonus I > > > could rip of the logic that deals with remembering the time? > > > > > > Best regards, > > > Maxim Levitsky > > So, timeout report is just another sample, with a mark attached, that > this is last sample? right? On a measurement timeout, the Conexant hardware RX FIFO has this special timer overflow value in it as the last measurement: value = 0x1ffff => a mark with a measurement of 65535 * 4 clocks (and the measurement before this one in the FIFO is usually the last actual mark received). I ultimately translate that to pulse = false; /* a space */ duration = 0x7fffffff; /* 2.147 seconds */ to give the in kernel decoders a final space. What is lost is the actual space measurement by the hardware (whatever 65535 * 4 Rx clocks is), before the timeout. If LIRC likes to measure intertransmission gaps, what I am currently doing will not give LIRC a reasonable gap estimate/measurement, if the timeout is shorter than the actual gap. > Christoph, right? > > In that case, lets do that this way: > > As soon as timeout is reached, I just send lirc the timeout report. > Then next keypress will start with pulse. > > I think this is the best solution. I'm flexible. I don't know LIRC internals well enough to know what's best. I suspect sending a valid space measurement of the timeout, before the timeout report, may be useful for LIRC to obtain information on the gaps that are longer than the hardware timeout. Regards, Andy > Best regards, > Maxim Levitsky > -- To unsubscribe from this list: send the line "unsubscribe linux-input" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
