"brd +" is not valid for ipv6. This causes the 'ip addr add' command to
fail with the message "Broadcast can be set only for IPv4 addresses".
So: don't use "brd +" for ipv6.
---
modules.d/40network/ifup.sh | 9 ++++++---
1 file changed, 6 insertions(+), 3 deletions(-)
diff --git a/modules.d/40network/ifup.sh b/modules.d/40network/ifup.sh
index f785968..245b450 100755
--- a/modules.d/40network/ifup.sh
+++ b/modules.d/40network/ifup.sh
@@ -105,10 +105,13 @@ do_static() {
wait_for_if_up $netif
[ -n "$macaddr" ] && ip link set address $macaddr
[ -n "$mtu" ] && ip link set mtu $mtu
- # do not flush addr for ipv6
- strstr $ip '*:*:*' || \
+ if strstr $ip '*:*:*'; then
+ # note no ip addr flush for ipv6
+ ip addr add $ip/$mask dev $netif
+ else
ip addr flush dev $netif
- ip addr add $ip/$mask brd + dev $netif
+ ip addr add $ip/$mask brd + dev $netif
+ fi
[ -n "$gw" ] && echo ip route add default via $gw dev $netif > /tmp/net.$netif.gw
[ -n "$hostname" ] && echo "echo $hostname > /proc/sys/kernel/hostname" > /tmp/net.$netif.hostname
--
1.7.10.2
--
To unsubscribe from this list: send the line "unsubscribe initramfs" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
