From: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx>
The regulator enables were after the check on the chip variant, which was
very unlikely to return a correct value when not powered.
Presumably all the device anyone is testing on have a regulator that
is already powered up when this code runs for reasons beyond the scope
of this driver. Move the read call down a few lines.
Fixes: 3cf7ded15e40 ("iio: accel: bma400: basic regulator support")
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@xxxxxxxxxx>
Cc: Dan Robertson <dan@xxxxxxxxxxxxxxx>
---
drivers/iio/accel/bma400_core.c | 24 ++++++++++++------------
1 file changed, 12 insertions(+), 12 deletions(-)
diff --git a/drivers/iio/accel/bma400_core.c b/drivers/iio/accel/bma400_core.c
index e8de88e6cfb9..81bfec9e20cc 100644
--- a/drivers/iio/accel/bma400_core.c
+++ b/drivers/iio/accel/bma400_core.c
@@ -869,18 +869,6 @@ static int bma400_init(struct bma400_data *data)
unsigned int val;
int ret;
- /* Try to read chip_id register. It must return 0x90. */
- ret = regmap_read(data->regmap, BMA400_CHIP_ID_REG, &val);
- if (ret) {
- dev_err(data->dev, "Failed to read chip id register\n");
- return ret;
- }
-
- if (val != BMA400_ID_REG_VAL) {
- dev_err(data->dev, "Chip ID mismatch\n");
- return -ENODEV;
- }
-
data->regulators[BMA400_VDD_REGULATOR].supply = "vdd";
data->regulators[BMA400_VDDIO_REGULATOR].supply = "vddio";
ret = devm_regulator_bulk_get(data->dev,
@@ -902,6 +890,18 @@ static int bma400_init(struct bma400_data *data)
if (ret)
return ret;
+ /* Try to read chip_id register. It must return 0x90. */
+ ret = regmap_read(data->regmap, BMA400_CHIP_ID_REG, &val);
+ if (ret) {
+ dev_err(data->dev, "Failed to read chip id register\n");
+ return ret;
+ }
+
+ if (val != BMA400_ID_REG_VAL) {
+ dev_err(data->dev, "Chip ID mismatch\n");
+ return -ENODEV;
+ }
+
ret = bma400_get_power_mode(data);
if (ret) {
dev_err(data->dev, "Failed to get the initial power-mode\n");
--
2.37.2
