This patchset adds support for the bma023, bma150, and smb380 three axis accelerometers to the bma180 IIO driver. The bma023 is found on several ~2010 phones, including the first-gen Galaxy S series. The bma023 differs from later chips (bma180, bma25x) in that it has no low power but still working mode and no temperature channel. The bma150 is very similar to the bma023, but has a temperature channel. As these chips are also supported by an input driver, the bma180 IIO driver now explicitly conflicts with INPUT_BMA150 in the Kconfig. While I was at it, I noticed that the dt binding doc was missing the regulators, so I've added those in. The patches have been tested on a GT-i9000 with a bma023. The interrupt pin is not connected on this board so the trigger was not tested. The bma150 was only tested by changing the compatible and confirming that the accelerometer channels were working. Changes from v1: -Added patches for bma150 and smb380 variants -Add R-b and A-b tags -Change so BMA180 and INPUT_BMA150 conflict rather than removing the i2c ids from the input driver when the iio driver is enabled Jonathan Bakker (7): iio: accel: bma180: Prepare for different reset values iio: accel: Make bma180 conflict with input's bma150 dt-bindings: iio: accel: Add bma150 family compatibles to bma180 dt-bindings: iio: accel: Add required regulators to bma180 iio: accel: bma180: Add support for bma023 iio: accel: bma180: Rename center_temp to temp_offset iio: accel: Add bma150/smb380 support to bma180 .../devicetree/bindings/iio/accel/bma180.txt | 8 +- drivers/iio/accel/Kconfig | 8 +- drivers/iio/accel/bma180.c | 208 ++++++++++++++++-- 3 files changed, 206 insertions(+), 18 deletions(-) -- 2.20.1
