During initial submission the selection of the channel was done using
the scan_index member of the iio_chan_spec structure. It was an abuse
because this member is supposed to be used with a buffer so it was
removed.
However there was still the need to be able to known how to select a
channel, the correct member to store this information is address.
Thanks to this it is possible to select any other channel than the
channel 0.
Fixes: 8dd2d7c0fed7 ("iio: adc: Add driver for the TI ADS8344 A/DC chips")
Signed-off-by: Gregory CLEMENT <gregory.clement@xxxxxxxxxxx>
---
drivers/iio/adc/ti-ads8344.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/drivers/iio/adc/ti-ads8344.c b/drivers/iio/adc/ti-ads8344.c
index 9a460807d46d..d384ca3437da 100644
--- a/drivers/iio/adc/ti-ads8344.c
+++ b/drivers/iio/adc/ti-ads8344.c
@@ -32,16 +32,17 @@ struct ads8344 {
u16 rx_buf;
};
-#define ADS8344_VOLTAGE_CHANNEL(chan, si) \
+#define ADS8344_VOLTAGE_CHANNEL(chan, addr) \
{ \
.type = IIO_VOLTAGE, \
.indexed = 1, \
.channel = chan, \
.info_mask_separate = BIT(IIO_CHAN_INFO_RAW), \
.info_mask_shared_by_type = BIT(IIO_CHAN_INFO_SCALE), \
+ .address = addr, \
}
-#define ADS8344_VOLTAGE_CHANNEL_DIFF(chan1, chan2, si) \
+#define ADS8344_VOLTAGE_CHANNEL_DIFF(chan1, chan2, addr) \
{ \
.type = IIO_VOLTAGE, \
.indexed = 1, \
@@ -50,6 +51,7 @@ struct ads8344 {
.differential = 1, \
.info_mask_separate = BIT(IIO_CHAN_INFO_RAW), \
.info_mask_shared_by_type = BIT(IIO_CHAN_INFO_SCALE), \
+ .address = addr, \
}
static const struct iio_chan_spec ads8344_channels[] = {
@@ -105,7 +107,7 @@ static int ads8344_read_raw(struct iio_dev *iio,
switch (mask) {
case IIO_CHAN_INFO_RAW:
mutex_lock(&adc->lock);
- *value = ads8344_adc_conversion(adc, channel->scan_index,
+ *value = ads8344_adc_conversion(adc, channel->address,
channel->differential);
mutex_unlock(&adc->lock);
if (*value < 0)
--
2.26.1
