We need to perform a reset a start up to make sure that the chip is in a consistent state. This reset also disables all the interrupts which should only be enabled together with the iio buffer. Not doing this, was sometimes causing unwanted interrupts to trigger. Signed-off-by: Stefan Popa <stefan.popa@xxxxxxxxxx> --- Changes in v2: - Instead of disabling the interrupts, now this patch performs a software reset. drivers/iio/accel/adxl372.c | 8 ++++++++ 1 file changed, 8 insertions(+) diff --git a/drivers/iio/accel/adxl372.c b/drivers/iio/accel/adxl372.c index 33edca8..8a00528 100644 --- a/drivers/iio/accel/adxl372.c +++ b/drivers/iio/accel/adxl372.c @@ -575,6 +575,14 @@ static int adxl372_setup(struct adxl372_state *st) return -ENODEV; } + /* + * Perform a software reset to make sure the device is in a consistent + * state after start up. + */ + ret = regmap_write(st->regmap, ADXL372_RESET, ADXL372_RESET_CODE); + if (ret < 0) + return ret; + ret = adxl372_set_op_mode(st, ADXL372_STANDBY); if (ret < 0) return ret; -- 2.7.4
