On 09/09/2019 13.55, Lorenzo Bianconi wrote:
When events and buffered reads is enabled simultaneously, and the first
event accours the interrupt pin stays high.
This can be reverted when we find a solution to allow events and
buffered reads simultaneously.
Signed-off-by: Sean Nyekjaer <sean@xxxxxxxxxx>
---
Changes since v4:
* Use fifo configuration mutex to prevent a race in hw->enable_event check.
Changes since v5:
* Updated do not return without unlocking mutexes
* Lock mutex before unlock
* Runtime tested ;-)
[...]
--- a/drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c
+++ b/drivers/iio/imu/st_lsm6dsx/st_lsm6dsx_core.c
@@ -1340,8 +1340,12 @@ static int st_lsm6dsx_write_event_config(struct iio_dev *iio_dev,
if (type != IIO_EV_TYPE_THRESH)
return -EINVAL;
- if (hw->fifo_mode != ST_LSM6DSX_FIFO_BYPASS)
- return -EBUSY;
+ mutex_lock(&hw->conf_lock);
+
+ if (hw->fifo_mode != ST_LSM6DSX_FIFO_BYPASS) {
+ err = -EBUSY;
+ goto out;
+ }
This patch is still broken!!! Returning in case of error you need to relase the
lock.
Hmm,
please read below this:
- return 0;
+out:
+ mutex_unlock(&hw->conf_lock);
+
+ return err;
/* do not enable events if they are already enabled */
if (state && hw->enable_event)
@@ -1357,7 +1361,10 @@ static int st_lsm6dsx_write_event_config(struct iio_dev *iio_dev,
hw->enable_event = state;
- return 0;
+out:
+ mutex_unlock(&hw->conf_lock);
+
+ return err;
}
int st_lsm6dsx_set_watermark(struct iio_dev *iio_dev, unsigned int val)
--
2.23.0
