On Wed, 7 Aug 2019, Beniamin Bia wrote: minor comment below > Documentation for AD7606B Analog to Digital Converter and software > mode was added. > > Signed-off-by: Beniamin Bia <beniamin.bia@xxxxxxxxxx> > --- > Changes in v2: > -nothing changed > > Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml | 4 +++- > 1 file changed, 3 insertions(+), 1 deletion(-) > > diff --git a/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml b/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml > index 509dbe9c84d2..2afe31747a70 100644 > --- a/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml > +++ b/Documentation/devicetree/bindings/iio/adc/adi,ad7606.yaml > @@ -13,6 +13,7 @@ maintainers: > description: | > Analog Devices AD7606 Simultaneous Sampling ADC > https://www.analog.com/media/en/technical-documentation/data-sheets/ad7606_7606-6_7606-4.pdf > + https://www.analog.com/media/en/technical-documentation/data-sheets/AD7606B.pdf > https://www.analog.com/media/en/technical-documentation/data-sheets/AD7616.pdf > > properties: > @@ -22,6 +23,7 @@ properties: > - adi,ad7606-8 > - adi,ad7606-6 > - adi,ad7606-4 > + - adi,ad7606b > - adi,ad7616 > > reg: > @@ -87,7 +89,7 @@ properties: > > adi,sw-mode: > description: > - Software mode of operation, so far available only for ad7616. > + Software mode of operation, so far available only for ad7616 and ad7606B. how about ad7606b to match the properties above? > It is enabled when all three oversampling mode pins are connected to > high level. The device is configured by the corresponding registers. If the > adi,oversampling-ratio-gpios property is defined, then the driver will set the > -- Peter Meerwald-Stadler Mobile: +43 664 24 44 418
