On Fri, 15 Mar 2019 13:14:25 +0200 Mircea Caprioru <mircea.caprioru@xxxxxxxxxx> wrote: > This patch removes the goto out statement thus ensuring that an error is > report as soon as it occurs. This gives more information and improves > readability. No problem with the patch, but I'm not sure why it gives more information? Gone from printing an useless error message to printing none. I'll just drop that bit of the description in favour of code readability. Hope you don't mind! Jonathan > > Signed-off-by: Mircea Caprioru <mircea.caprioru@xxxxxxxxxx> > --- > drivers/staging/iio/adc/ad7192.c | 13 +++++-------- > 1 file changed, 5 insertions(+), 8 deletions(-) > > diff --git a/drivers/staging/iio/adc/ad7192.c b/drivers/staging/iio/adc/ad7192.c > index ebab75bdeed7..27f962b8c4ef 100644 > --- a/drivers/staging/iio/adc/ad7192.c > +++ b/drivers/staging/iio/adc/ad7192.c > @@ -236,13 +236,13 @@ static int ad7192_setup(struct ad7192_state *st, > /* reset the serial interface */ > ret = ad_sd_reset(&st->sd, 48); > if (ret < 0) > - goto out; > + return ret; > usleep_range(500, 1000); /* Wait for at least 500us */ > > /* write/read test for device presence */ > ret = ad_sd_read_reg(&st->sd, AD7192_REG_ID, 1, &id); > if (ret) > - goto out; > + return ret; > > id &= AD7192_ID_MASK; > > @@ -310,15 +310,15 @@ static int ad7192_setup(struct ad7192_state *st, > > ret = ad_sd_write_reg(&st->sd, AD7192_REG_MODE, 3, st->mode); > if (ret) > - goto out; > + return ret; > > ret = ad_sd_write_reg(&st->sd, AD7192_REG_CONF, 3, st->conf); > if (ret) > - goto out; > + return ret; > > ret = ad7192_calibrate_all(st); > if (ret) > - goto out; > + return ret; > > /* Populate available ADC input ranges */ > for (i = 0; i < ARRAY_SIZE(st->scale_avail); i++) { > @@ -332,9 +332,6 @@ static int ad7192_setup(struct ad7192_state *st, > } > > return 0; > -out: > - dev_err(&st->sd.spi->dev, "setup failed\n"); > - return ret; > } > > static ssize_t