Hi, On Fri, Jun 09, 2017 at 10:07:15AM +0300, Eugen Hristev wrote: > This patch implements the hardware triggers support and buffer management > for sama5d2. > The DT modifications ( [PATCH v4 1/4] ARM: dts: at91: sama5d2_xplained: > enable ADTRG pin) are for demonstration purposes of the feature, > setting the pinctrl for the ADC hw trigger pin,should go through > at91 maintainers. > As discussed on the mailing list, since we have a single external trigger > namely the ADTRG, but three different possible edges that can trigger it, > will have a single trigger in the IIO subsystem and three possible edges > which can be selected from the device tree. > Thus I created new bindings in the device tree for having the possible > edge types for the ADTRG pin. > The documentation for the bindings is in the patch > [PATCH v4 2/4] Documentation: dt: iio: at91-sama5d2_adc: add adtrg > trigger binding > The modifications in the DT are in the patch > [PATCH v4 3/4] ARM: dts: at91: sama5d2: add ADC hw trigger > The new property must be set with the values from interrupt edge types, as this > pin is effectively an internal interrupt. > If the reuse of IRQ macros in the trigger case is accepted, you can add Acked-by: Ludovic Desroches <ludovic.desroches@xxxxxxxxxxxxx> for the next version with the corrections suggested by Jonathan. Regards Ludovic > Changes in v4: > - Modified bindings to be similar with interrupts > - Used iio claim direct to make sure buffer is not enabled when someone might > try to use a software triggered conversion > > Changes in v3: > - No longer have all three possible triggers registered in the subsystem and > available in the sysfs. Only registering one trigger, and the possible edge > is being read from the device tree. In the device tree, any possible edge > can be set. There are three already made nodes for each possible edge which > can be selected. > - Fixed a bug where software triggered conversion could be started even if > the hardware trigger was enabled. > - Preallocate enough space for the buffer, considering all the channels > and timestamp > > > > Changes in v2: > - Moved buffer allocation and freeing into the preenable and postdisable > callbacks. > We have a total of scan bytes that can vary a lot depending on each channel > enabled at a certain point. > - made the at91 trigger list part of state structure > - made the iio trigger list preallocated in state structure > - moved irq enabling/disabling into the try_reenable callback > - on trigger disable must write disable registries as well > - Modified trigger name length to 64 > > > Eugen Hristev (4): > ARM: dts: at91: sama5d2_xplained: enable ADTRG pin > Documentation: dt: iio: at91-sama5d2_adc: add hw trigger edge binding > ARM: dts: at91: sama5d2: add ADC hw trigger edge type > iio: adc: at91-sama5d2_adc: add hw trigger and buffer support > > .../bindings/iio/adc/at91-sama5d2_adc.txt | 6 + > arch/arm/boot/dts/at91-sama5d2_xplained.dts | 16 +- > arch/arm/boot/dts/sama5d2.dtsi | 1 + > drivers/iio/adc/at91-sama5d2_adc.c | 236 ++++++++++++++++++++- > 4 files changed, 253 insertions(+), 6 deletions(-) > > -- > 2.7.4 > -- To unsubscribe from this list: send the line "unsubscribe linux-iio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
