On Mon, 13 Feb 2017, Arnaud Pouliquen wrote:
> Add bindings that describe Digital Filter for Sigma Delta
> Modulators. DFSDM allows to connect sigma delta
> modulators and/or PDM microphones.
nitpicking on typos below
> Signed-off-by: Arnaud Pouliquen <arnaud.pouliquen@xxxxxx>
> ---
> .../bindings/iio/adc/st,stm32-dfsdm-adc.txt | 125 +++++++++++++++++++++
> 1 file changed, 125 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/iio/adc/st,stm32-dfsdm-adc.txt
>
> diff --git a/Documentation/devicetree/bindings/iio/adc/st,stm32-dfsdm-adc.txt b/Documentation/devicetree/bindings/iio/adc/st,stm32-dfsdm-adc.txt
> new file mode 100644
> index 0000000..83937cb
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/iio/adc/st,stm32-dfsdm-adc.txt
> @@ -0,0 +1,125 @@
> +STMicroelectronics STM32 DFSDM ADC device driver
> +
> +
> +STM32 DFSDM ADC is a sigma delta analog-to-digital converter dedicted to
> +interface external sigma delta modulators to stm32 micro controlers.
controllers
> +it is mainly targeted for:
It
> +- Sigma delta modulators ( motor control, metering...)
(motor
> +- PDM microphones ( audio digital microphone)
(audio
> +
> +It featured with up to 8 serial digital interface (SPI or Manchester) and
It features up
> +up to 4 filters.
> +
> +Each instance of the sub-drivers uses one filter instance.
> +
> +Contents of a stm32 dfsdmc root node:
what is the c in dfsdmc?
> +-------------------------------------
> +Required properties:
> +- compatible: Should be "st,stm32-dfsdm-adc".
> +- reg: Offset and length of the DFSDM block register set.
> +- clocks: IP and serial interfaces clocking. Should be set according
> + to rcc clock ID and "clock-names".
> +- clock-names: Input clock name "dfsdm" must be defined,
> + "audio" is optional. If defined CLKOUT is based on the audio
> + clock, else "dfsdm" is used.
> +- clocks: Clock for the analog circuitry (common to all ADCs).
> +- clock-names: Must be "adc".
> +
> +Optional properties:
> +- st,clkout-freq: needed for SPI master mode
> + SPI clock OUT frequency (Hz).This clock must be set according
. This
> + to "clock" property. Frequency must be a multiple of the rcc
> + clock frequency. If not, clkout frequency will not be
> + accurate.
> +
> +Contents of a stm32 DFSDM child nodes:
> +----------------------------------------
> +
> +Required properties:
> +- compatible: Must be:
> + "st,stm32-dfsdm-adc" for sigma delta ADCs
> + "st,stm32-dfsdm-pdm" for audio digital microphone.
> +- reg: Specifies the DFSDM filter instance.
> +- interrupts: IRQ lines connected to each DFSDM filter instance.
> +- st,adc-channels: List of single-ended channels muxed for this ADC.
> +- st,adc-channel-names: List of single-ended channels Name.
channel names
> +- st,dai-filter-order: SinC filter order from 0 to 5.
> + 0: FastSinC
> + [1-5]: order 1 to 5.
> + For audio purpose it is recommended to use order 3 to 5.
> +
> +Required properties for "st,stm32-dfsdm-adc" compatibility:
> +- #io-channel-cells = <1>: See the IIO bindings section "IIO consumers".
> +- io-channels: from common iio binding. use to pipe external sigma delta
> + modulator or internal ADC output to dfsdm channel.
> +
> +Required properties for "st,stm32-dfsdm-pdm" compatibility:
> +- #sound-dai-cells: must be set to 0.
> +- dma: DMA controller phandle and DMA request line associated to the
> + filter instance ( specified by the field "reg")
(specified
> +- dma-names: must be "rx"
> +
> +Optional properties:
> +- st,adc-channel-types: Single-ended channel input type. Default value is 0.
> + - "SPI_R": SPI with data on rising edge (default)
> + - "SPI_F": SPI with data on falling edge
> + - "MANCH_R": manchester codec, rising edge = logic 0
> + - "MANCH_F": manchester codec, falling edge = logic 1
> +- st,adc-channel-clk-src: Conversion clock source. default value is 1.
Default
> + - "CLKIN": External SPI clock (CLKIN x)
external
> + - "CLKOUT": internal SPI clock (CLKOUT) (default)
> + - "CLKOUT_F": internal SPI clock divided by 2 (falling edge).
> + - "CLKOUT_R": internal SPI clock divided by 2 (rising edge).
> +
> +- st,adc-alt-channel: Must be defined if Two sigma delta modulator are
two
> + connected on same SPI input.
> + If not set channel n is connected to SPI input n.
If not set,
> + If set channel n is connected to SPI input n + 1.
If set,
> +
> +- st,filter0-sync: Set to 1 to synchronize with DFSDM filter instance 0.
> + to used for multi microphone synchronization.
Used for
> +
> +Example of a sigma delta adc purpose:
> + ads1202: simple_sd_adc@0 {
> + compatible = "sd-modulator";
> + #io-channel-cells = <1>;
> + status = "okay";
> + };
> + dfsdm: dfsdm@40017000 {
> + compatible = "st,stm32h7-dfsdm";
> + reg = <0x40017000 0x400>;
> + clocks = <&timer_clk>;
> + clock-names = "dfsdm";
> +
> + dfsdm_adc0: dfsdm-adc0@0 {
> + compatible = "st,stm32-dfsdm-adc";
> + #io-channel-cells = <1>;
> + reg = <0>;
> + interrupts = <110>;
> + st,adc-channels = <0>;
> + st,adc-channel-names = "in0";
> + st,adc-channel-types = "SPI_R";
> + st,adc-channel-clk-src = "CLKOUT";
> + io-channels = <&ads1202 0>;
> + };
> +
> +Example of a pdm microphone purpose:
> + dfsdm: dfsdm@40017000 {
> + compatible = "st,stm32h7-dfsdm";
> + reg = <0x40017000 0x400>;
> + clocks = <&timer_clk>;
> + clock-names = "dfsdm";
> +
> + dfsdm_pdm0: dfsdm-pdm@0 {
> + compatible = "st,stm32-dfsdm-pdm";
> + #sound-dai-cells = <0>;
> + reg = <0>;
> + interrupts = <110>;
> + dmas = <&dmamux1 102 0x400 0x00>;
> + dma-names = "rx";
> + st,adc-channels = <0>;
> + st,adc-channel-names = "pdm1";
> + st,adc-channel-types = "SPI_R";
> + st,adc-channel-clk-src = "CLKOUT";
> + };
> + }
>
--
Peter Meerwald-Stadler
+43-664-2444418 (mobile)
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
