On 2017-01-27 20:39, Rob Herring wrote: > On Wed, Jan 18, 2017 at 04:57:10PM +0100, Peter Rosin wrote: >> Describe how a generic multiplexer controller is used to mux an i2c bus. >> >> Acked-by: Jonathan Cameron <jic23@xxxxxxxxxx> >> Signed-off-by: Peter Rosin <peda@xxxxxxxxxx> >> --- >> .../devicetree/bindings/i2c/i2c-mux-simple.txt | 81 ++++++++++++++++++++++ >> 1 file changed, 81 insertions(+) >> create mode 100644 Documentation/devicetree/bindings/i2c/i2c-mux-simple.txt >> >> diff --git a/Documentation/devicetree/bindings/i2c/i2c-mux-simple.txt b/Documentation/devicetree/bindings/i2c/i2c-mux-simple.txt >> new file mode 100644 >> index 000000000000..253d5027843b >> --- /dev/null >> +++ b/Documentation/devicetree/bindings/i2c/i2c-mux-simple.txt >> @@ -0,0 +1,81 @@ >> +Simple I2C Bus Mux >> + >> +This binding describes an I2C bus multiplexer that uses a mux controller >> +from the mux subsystem to route the I2C signals. >> + >> + .-----. .-----. >> + | dev | | dev | >> + .------------. '-----' '-----' >> + | SoC | | | >> + | | .--------+--------' >> + | .------. | .------+ child bus A, on MUX value set to 0 >> + | | I2C |-|--| Mux | >> + | '------' | '--+---+ child bus B, on MUX value set to 1 >> + | .------. | | '----------+--------+--------. >> + | | MUX- | | | | | | >> + | | Ctrl |-|-----+ .-----. .-----. .-----. >> + | '------' | | dev | | dev | | dev | >> + '------------' '-----' '-----' '-----' >> + >> +Required properties: >> +- compatible: i2c-mux-simple,mux-locked or i2c-mux-simple,parent-locked > > Not a fan of using "simple" nor the ','. Perhaps lock type should be > separate property. How about just i2c-mux for the compatible? Because i2c-mux-mux (which follows the naming of previous i2c muxes) looks really stupid. Or perhaps i2c-mux-generic? I'm also happy to have the lock type as a separate property. One lock type, e.g. parent-locked, could be the default and adding a 'mux-locked' property could change that. Would that be ok? Or should it be a requirement that one of 'mux-locked'/'parent-locked' is always present? > I'm not sure I get the mux vs. parent locked fully. How do I determine > what type I have? We already have bindings for several types of i2c > muxes. How does the locking annotation fit into those? We have briefly discussed this before [1] in the context of i2c-mux-gpio and i2c-mux-pinctrl, when I added the mux-locked/parent-locked distinction to the i2c-mux infrastructure (it wasn't named mux-locked/parent-locked way back then though). There is more detail on what the difference is between the two in Documentation/i2c/i2c-topology. Side note regarding your remark "use an I2C controlled mux instead"; it appears that I'm not alone [2] with this kind of requirement... [1] https://lkml.org/lkml/2016/1/6/437 [2] http://marc.info/?t=147877959100002&r=1&w=2 But, now that I have pondered on this for a year or so, I firmly believe it was a mistake to have the code in i2c-mux-gpio and i2c-mux-pinctrl automatically try to deduce if the mux should be mux-locked or parent-locked. It might be easy to make that call in some trivial cases, but it is not difficult to dream up scenarios where it would be extremely hard for the code to get this decision right. It's just fragile. But now we have code in those two muxes that has unwanted tentacles into the guts of the gpio and pinctrl subsystems. Hopefully those unwanted tentacles can be replaced with something based on device links? However, it is still not hard to come up with scenarios that will require manual intervention in order to select the right kind of i2c mux locking. So, I fear that we have inadequate code trying to make a decision automatically, and that we at some point down the line will have some impossible case needing a binding that trumps the heuristic. Why have a heuristic at all in that case? In short, it should have been a binding from the start, methinks. That was a long rant regarding i2c-mux-gpio and i2c-mux-pinctrl. I obviously think it is bad to have this new i2c mux go in the same direction as those two drivers. I.e. I think a binding that specifies the desired locking is preferable to any attempted heuristic. Cheers, peda -- To unsubscribe from this list: send the line "unsubscribe linux-iio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
