<snip>...
> >> > > > >
> >> > > > > Indeed it is the pm_runtime_get_sync that fails with a -EINVAL.
> >> > > > >
> >> > > > > > >
> >> > > > > > > When I comment out the break the readings come back but
> >> > > > > > > are not
> >> > > updated continually.
> >> > > > > > > If I read in_voltage0-voltage1_raw then in_voltage0_raw
> >> > > > > > > the value
> >> > is
> >> > > updated.
> >> > > > > >
> >> > > > > > I guess this is normal if set_power_state fails.
> >> > > > >
> >> > > > > The hwmod driver works fine BTW.
> >> > > > >
> >> > > > > My guess is there is an issue with the qup i2c driver seeing
> >> > > > > as it has worked on other system without issue.
> >> > > > >
> >> > > > > CC'd some the latest developer on the qup i2c driver.
> >> > > > >
> >> > > > > I2C guys have any ideas on this?
> >> > > > >
> >> > > >
> >> > > > Adding some more people who recently worked on this. Might be
> >> > > > nice to know which kernel version you are using.
> >> > > >
> >> > Which i2c bus is this connected to ? I can give a try with 410c to
> >> > see why pm_runtime_get_sync from qup fails.
> >>
> >> It is on the lowspeed header. Here is my devicetree entry:
> >>
> >> i2c@78b6000 {
> >> /* On Low speed expansion */
> >> label = "LS-I2C0";
> >> status = "okay";
> >>
> >> pca: pca@40 {
> >> compatible = "nxp,pca9685-pwm";
> >> #pwm-cells = <2>;
> >> reg = <0x40>;
> >> };
> >>
> >> adc: adc@48 {
> >> compatible = "ti,ads1015";
> >> reg = <0x48>;
> >> };
> >> };
> >
> > Whats the sequence in which the failure happens ?
> >
> > I tested on DB410c by adding the DT entry that you mentioned above on
> > 4.5-rc2 and rc3.
> > I see that the i2c transfers call from pca9685 during
> > pca9685_pwm_probe did go through and no failure from
> > pm_runtime_get_sync
>
> Hi Sricharan,
>
> Are you looking at pca9685_pwm_probe in drivers/pwm/pwm-pca9685.c
> right?
>
Yes.
> I'm asking this because this driver doesn't seem to support runtime pm and
> there is no check for regmap_write/regmap_write return code in the probe
> function.
Hmm to be clear, so it’s the pm_runtime_getsync from i2c-qup which fails right ?
I was tracking that when there are i2c_xfers from pwm. I did not see any failures there.
So wanted to know the correct sequence to reproduce.
Regards,
Sricharan
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
