On 18/07/15 13:30, Stefan Wahren wrote:
> This patch fix some spelling errors in the comments.
>
> Signed-off-by: Stefan Wahren <stefan.wahren@xxxxxxxx>
Applied.
> ---
> drivers/staging/iio/adc/mxs-lradc.c | 10 +++++-----
> 1 file changed, 5 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/staging/iio/adc/mxs-lradc.c b/drivers/staging/iio/adc/mxs-lradc.c
> index 1ccb367..386a44d 100644
> --- a/drivers/staging/iio/adc/mxs-lradc.c
> +++ b/drivers/staging/iio/adc/mxs-lradc.c
> @@ -65,14 +65,14 @@
> * Once the pen touches the touchscreen, the touchscreen switches from
> * IRQ-driven mode to polling mode to prevent interrupt storm. The polling
> * is realized by worker thread, which is called every 20 or so milliseconds.
> - * This gives the touchscreen enough fluence and does not strain the system
> + * This gives the touchscreen enough fluency and does not strain the system
> * too much.
> */
> #define LRADC_TS_SAMPLE_DELAY_MS 5
>
> /*
> * The LRADC reads the following amount of samples from each touchscreen
> - * channel and the driver then computes avarage of these.
> + * channel and the driver then computes average of these.
> */
> #define LRADC_TS_SAMPLE_AMOUNT 4
>
> @@ -238,7 +238,7 @@ struct mxs_lradc {
> * CH5 -- Touch screen YNLR
> * CH6 -- Touch screen WIPER (5-wire only)
> *
> - * The bitfields below represents which parts of the LRADC block are
> + * The bit fields below represents which parts of the LRADC block are
> * switched into special mode of operation. These channels can not
> * be sampled as regular LRADC channels. The driver will refuse any
> * attempt to sample these channels.
> @@ -252,7 +252,7 @@ struct mxs_lradc {
> struct input_dev *ts_input;
>
> enum mxs_lradc_id soc;
> - enum lradc_ts_plate cur_plate; /* statemachine */
> + enum lradc_ts_plate cur_plate; /* state machine */
> bool ts_valid;
> unsigned ts_x_pos;
> unsigned ts_y_pos;
> @@ -812,7 +812,7 @@ static int mxs_lradc_read_single(struct iio_dev *iio_dev, int chan, int *val)
> int ret;
>
> /*
> - * See if there is no buffered operation in progess. If there is, simply
> + * See if there is no buffered operation in progress. If there is, simply
> * bail out. This can be improved to support both buffered and raw IO at
> * the same time, yet the code becomes horribly complicated. Therefore I
> * applied KISS principle here.
>
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
