Change the mode to push/pull type instead of open drain as some
platforms fails to drive the GPIO pin with open drain.
Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@xxxxxxxxxxxxxxx>
---
drivers/iio/gyro/bmg160.c | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/drivers/iio/gyro/bmg160.c b/drivers/iio/gyro/bmg160.c
index 3476133..0b9e813 100644
--- a/drivers/iio/gyro/bmg160.c
+++ b/drivers/iio/gyro/bmg160.c
@@ -67,6 +67,9 @@
#define BMG160_REG_INT_EN_0 0x15
#define BMG160_DATA_ENABLE_INT BIT(7)
+#define BMG160_REG_INT_EN_1 0x16
+#define BMG160_INT1_BIT_OD BIT(1)
+
#define BMG160_REG_XOUT_L 0x02
#define BMG160_AXIS_TO_REG(axis) (BMG160_REG_XOUT_L + (axis * 2))
@@ -222,6 +225,19 @@ static int bmg160_chip_init(struct bmg160_data *data)
data->slope_thres = ret;
/* Set default interrupt mode */
+ ret = i2c_smbus_read_byte_data(data->client, BMG160_REG_INT_EN_1);
+ if (ret < 0) {
+ dev_err(&data->client->dev, "Error reading reg_int_en_1\n");
+ return ret;
+ }
+ ret &= ~BMG160_INT1_BIT_OD;
+ ret = i2c_smbus_write_byte_data(data->client,
+ BMG160_REG_INT_EN_1, ret);
+ if (ret < 0) {
+ dev_err(&data->client->dev, "Error writing reg_int_en_1\n");
+ return ret;
+ }
+
ret = i2c_smbus_write_byte_data(data->client,
BMG160_REG_INT_RST_LATCH,
BMG160_INT_MODE_LATCH_INT |
--
1.9.3
--
To unsubscribe from this list: send the line "unsubscribe linux-iio" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
