On Thu, May 30, 2024 at 11:28:17PM +0200, Niklas Cassel wrote:
> Commit 7627a0edef54 ("ata: ahci: Drop low power policy board type")
> dropped the board_ahci_low_power board type, and instead enables LPM if:
> -The AHCI controller reports that it supports LPM (Partial/Slumber), and
> -CONFIG_SATA_MOBILE_LPM_POLICY != 0, and
> -The port is not defined as external in the per port PxCMD register, and
> -The port is not defined as hotplug capable in the per port PxCMD
> register.
>
> Partial and Slumber LPM states can either be initiated by HIPM or DIPM.
>
> For HIPM (host initiated power management) to get enabled, both the AHCI
> controller and the drive have to report that they support HIPM.
>
> For DIPM (device initiated power management) to get enabled, only the
> drive has to report that it supports DIPM. However, the HBA will reject
> device requests to enter LPM states which the HBA does not support.
>
> The problem is that Crucial CT240BX500SSD1 drives do not handle low power
> modes correctly. The problem was most likely not seen before because no
> one had used this drive with a AHCI controller with LPM enabled.
>
> Add a quirk so that we do not enable LPM for this drive, since we see
> command timeouts if we do (even though the drive claims to support DIPM).
>
> Fixes: 7627a0edef54 ("ata: ahci: Drop low power policy board type")
> Cc: stable@xxxxxxxxxxxxxxx
> Reported-by: Aarrayy <lp610mh@xxxxxxxxx>
> Closes: https://bugzilla.kernel.org/show_bug.cgi?id=218832
> Signed-off-by: Niklas Cassel <cassel@xxxxxxxxxx>
Reviewed-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx>
