On Thu, May 02, 2024 at 06:40:11PM +0900, Damien Le Moal wrote:
> On 5/2/24 18:26, Niklas Cassel wrote:
> > From: Mario Limonciello <mario.limonciello@xxxxxxx>
> >
> > Historically this was set to "keep_firmware_settings" to prevent problems
> > with power management on very old drives. However it's been observed that
> > almost all modern Linux distributions either set the policy to
> > "med_power_with_dipm" in the kernel configuration or update it to this via
> > userspace policy changes. Update the policy default in the kernel to
> > "med_power_with_dipm" to match that behavior as well.
> >
> > Changing the default was previously not a good idea, because LPM disables
> > detection of hot plug removals, however, since commit ae1f3db006b7 ("ata:
> > ahci: do not enable LPM on external ports"), a port marked as external
> > will always be initialized to "keep_firmware_settings", regardless of the
> > SATA_MOBILE_LPM_POLICY Kconfig value. Therefore, changing the default is
> > now considered safe (external ports included).
> >
> > Signed-off-by: Mario Limonciello <mario.limonciello@xxxxxxx>
> > [cassel: rebased and reworded commit message]
> > Signed-off-by: Niklas Cassel <cassel@xxxxxxxxxx>
> > ---
> > drivers/ata/Kconfig | 2 +-
> > 1 file changed, 1 insertion(+), 1 deletion(-)
> >
> > diff --git a/drivers/ata/Kconfig b/drivers/ata/Kconfig
> > index b595494ab9b4..e00536b49552 100644
> > --- a/drivers/ata/Kconfig
> > +++ b/drivers/ata/Kconfig
> > @@ -118,7 +118,7 @@ config SATA_AHCI
> > config SATA_MOBILE_LPM_POLICY
> > int "Default SATA Link Power Management policy"
> > range 0 4
> > - default 0
> > + default 3
> > depends on SATA_AHCI
> > help
> > Select the Default SATA Link Power Management (LPM) policy to use
>
> I am OK with this change. However, for this one, given that we already are at
> mid-rc6, I really would prefer waiting for next cycle to have this spend more
> time in for-next testing. So let's apply this once 6.10-rc1 is out.
Sounds good to me.
Kind regards,
Niklas
