On 2/7/24 12:58 PM, Andrey Jr. Melnikov wrote:
> The ASM1064 SATA host controller always reports wrongly,
> that it has 24 ports. But in reality, it only has four ports.
>
> before:
> ahci 0000:04:00.0: SSS flag set, parallel bus scan disabled
> ahci 0000:04:00.0: AHCI 0001.0301 32 slots 24 ports 6 Gbps 0xffff0f impl SATA mode
> ahci 0000:04:00.0: flags: 64bit ncq sntf stag pm led only pio sxs deso sadm sds apst
>
> after:
> ahci 0000:04:00.0: ASM1064 has only four ports
> ahci 0000:04:00.0: forcing port_map 0xffff0f -> 0xf
> ahci 0000:04:00.0: SSS flag set, parallel bus scan disabled
> ahci 0000:04:00.0: AHCI 0001.0301 32 slots 24 ports 6 Gbps 0xf impl SATA mode
> ahci 0000:04:00.0: flags: 64bit ncq sntf stag pm led only pio sxs deso sadm sds apst
>
>
> Signed-off-by: Andrey Jr. Melnikov <temnota.am@xxxxxxxxx>
>
> diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
> index da2e74fce2d9..ec30d8330d16 100644
> --- a/drivers/ata/ahci.c
> +++ b/drivers/ata/ahci.c
> @@ -671,9 +671,14 @@ MODULE_PARM_DESC(mobile_lpm_policy, "Default LPM policy for mobile chipsets");
> static void ahci_pci_save_initial_config(struct pci_dev *pdev,
> struct ahci_host_priv *hpriv)
> {
> - if (pdev->vendor == PCI_VENDOR_ID_ASMEDIA && pdev->device == 0x1166) {
> - dev_info(&pdev->dev, "ASM1166 has only six ports\n");
> - hpriv->saved_port_map = 0x3f;
> + if (pdev->vendor == PCI_VENDOR_ID_ASMEDIA) {
> + if (pdev->device == 0x1166) {
Maybe *switch* instead?
> + dev_info(&pdev->dev, "ASM1166 has only six ports\n");
> + hpriv->saved_port_map = 0x3f;
> + } else if (pdev->device == 0x1064) {
> + dev_info(&pdev->dev, "ASM1064 has only four ports\n");
> + hpriv->saved_port_map = 0xf;
> + }
> }
>
> if (pdev->vendor == PCI_VENDOR_ID_JMICRON && pdev->device == 0x2361) {
MBR, Sergey
