From: Niklas Cassel <niklas.cassel@xxxxxxx>
The condition to fetch sense data was supposed to be:
ATA_SENSE set AND either
1) Command was NCQ and ATA_DFLAG_CDL_ENABLED flag set (flag
ATA_DFLAG_CDL_ENABLED will only be set if the Successful NCQ command
sense data supported bit is set); or
2) Command was non-NCQ and regular sense data reporting is enabled.
However the check in 2) accidentally had the negation at the wrong place,
causing it to try to fetch sense data if it was a non-NCQ command _or_
if regular sense data reporting was _not_ enabled.
Fix this by removing the extra parentheses that should not be there,
such that only the correct return (ata_is_ncq()) is negated.
Fixes: 18bd7718b5c4 ("scsi: ata: libata: Handle completion of CDL commands using policy 0xD")
Reported-by: Borislav Petkov <bp@xxxxxxxxx>
Closes: https://lore.kernel.org/linux-ide/20230722155621.GIZLv8JbURKzHtKvQE@fat_crate.local/
Signed-off-by: Niklas Cassel <niklas.cassel@xxxxxxx>
---
drivers/ata/libata-core.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c
index d37ab6087f2f..04db0f2c683a 100644
--- a/drivers/ata/libata-core.c
+++ b/drivers/ata/libata-core.c
@@ -4938,8 +4938,8 @@ void ata_qc_complete(struct ata_queued_cmd *qc)
if (qc->result_tf.status & ATA_SENSE &&
((ata_is_ncq(qc->tf.protocol) &&
dev->flags & ATA_DFLAG_CDL_ENABLED) ||
- (!(ata_is_ncq(qc->tf.protocol) &&
- ata_id_sense_reporting_enabled(dev->id))))) {
+ (!ata_is_ncq(qc->tf.protocol) &&
+ ata_id_sense_reporting_enabled(dev->id)))) {
/*
* Tell SCSI EH to not overwrite scmd->result even if
* this command is finished with result SAM_STAT_GOOD.
--
2.41.0
