The LPM policy is applied to more chipsets than just mobile designs.
Update the module parameter to drop the word "mobile" to make this
clearer to users.
Also, document this renamed parameter in the admin-guide for users
as it was missing previously.
Signed-off-by: Mario Limonciello <mario.limonciello@xxxxxxx>
---
Documentation/admin-guide/kernel-parameters.txt | 11 +++++++++++
drivers/ata/ahci.c | 10 +++++-----
2 files changed, 16 insertions(+), 5 deletions(-)
diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt
index 9336d98fc670..9e6bd212004d 100644
--- a/Documentation/admin-guide/kernel-parameters.txt
+++ b/Documentation/admin-guide/kernel-parameters.txt
@@ -268,6 +268,17 @@
try_unsupported: try to drive unsupported chipsets
(may crash computer or cause data corruption)
+ ahci.lpm_policy= [AHCI]
+ The Default SATA Link Power Management (LPM) policy to use
+ for chipsets / "South Bridges" supporting low-power modes.
+
+ The value set has the following meanings:
+ 0 => Keep firmware settings
+ 1 => Maximum performance
+ 2 => Medium power
+ 3 => Medium power with Device Initiated PM enabled
+ 4 => Minimum power
+
ALSA [HW,ALSA]
See Documentation/sound/alsa-configuration.rst
diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c
index c39cdf6a44f1..1e2febea2f28 100644
--- a/drivers/ata/ahci.c
+++ b/drivers/ata/ahci.c
@@ -640,9 +640,9 @@ static int marvell_enable = 1;
module_param(marvell_enable, int, 0644);
MODULE_PARM_DESC(marvell_enable, "Marvell SATA via AHCI (1 = enabled)");
-static int mobile_lpm_policy = -1;
-module_param(mobile_lpm_policy, int, 0644);
-MODULE_PARM_DESC(mobile_lpm_policy, "Default LPM policy for mobile chipsets");
+static int lpm_policy = -1;
+module_param(lpm_policy, int, 0644);
+MODULE_PARM_DESC(lpm_policy, "Default LPM policy");
static void ahci_pci_save_initial_config(struct pci_dev *pdev,
struct ahci_host_priv *hpriv)
@@ -1591,8 +1591,8 @@ static void ahci_update_initial_lpm_policy(struct ata_port *ap,
int policy = CONFIG_SATA_MOBILE_LPM_POLICY;
/* user modified policy via module param */
- if (mobile_lpm_policy != -1) {
- policy = mobile_lpm_policy;
+ if (lpm_policy != -1) {
+ policy = lpm_policy;
goto update_policy;
}
--
2.34.1
