On some platform, when OS enables LPM by default (eg, min_power),
then, DIPM slumber request cannot be disallowed if ahci's CAP.PSC
is set to '1' and CAP.SSC is cleared to '0', which may cause ahci
to be an uncertain state (same for Partial).
In ahci spec, when CAP.PSC/SSC is cleared to '0', the PxSCTL.IPM
field must be programmed to disallow device initiated Partial/
Slumber request.
Adds support to control this case on actual LPM capability.
Signed-off-by: Runa Guo-oc <RunaGuo-oc@xxxxxxxxxxx>
---
drivers/ata/libata-sata.c | 12 +++++++++++-
1 file changed, 11 insertions(+), 1 deletion(-)
diff --git a/drivers/ata/libata-sata.c b/drivers/ata/libata-sata.c
index 7a5fe41..e6195cf 100644
--- a/drivers/ata/libata-sata.c
+++ b/drivers/ata/libata-sata.c
@@ -394,9 +394,19 @@ int sata_link_scr_lpm(struct ata_link *link, enum ata_lpm_policy policy,
case ATA_LPM_MED_POWER_WITH_DIPM:
case ATA_LPM_MIN_POWER_WITH_PARTIAL:
case ATA_LPM_MIN_POWER:
- if (ata_link_nr_enabled(link) > 0)
+ if (ata_link_nr_enabled(link) > 0) {
/* no restrictions on LPM transitions */
scontrol &= ~(0x7 << 8);
+
+ /* if controller does not support partial, then disallows it,
+ * the same for slumber
+ */
+ if (!(link->ap->host->flags & ATA_HOST_PART))
+ scontrol |= (0x1 << 8);
+
+ if (!(link->ap->host->flags & ATA_HOST_SSC))
+ scontrol |= (0x2 << 8);
+ }
else {
/* empty port, power off */
scontrol &= ~0xf;
--
2.7.4
