Checking if DMA is enabled should be done via the
ata_dma_enabled helper function, since the init state
0xff indicates disabled.
Change based on code review, not tested due to lack of hardware.
Signed-off-by: Reimar Döffinger <Reimar.Doeffinger@xxxxxx>
---
drivers/ata/pata_amd.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/ata/pata_amd.c b/drivers/ata/pata_amd.c
index c8acba162d02..154748cfcc79 100644
--- a/drivers/ata/pata_amd.c
+++ b/drivers/ata/pata_amd.c
@@ -66,7 +66,7 @@ static void timing_setup(struct ata_port *ap, struct ata_device *adev, int offse
if (peer) {
/* This may be over conservative */
- if (peer->dma_mode) {
+ if (ata_dma_enabled(peer)) {
ata_timing_compute(peer, peer->dma_mode, &apeer, T, UT);
ata_timing_merge(&apeer, &at, &at, ATA_TIMING_8BIT);
}
--
2.33.0
