Checking if DMA is enabled should be done via the ata_dma_enabled helper function, since the init state 0xff indicates disabled. This meant that ATA_CMD_READ_LOG_DMA_EXT was used and probed for before DMA was enabled, which caused hangs for some combinations of controllers and devices. It might also have caused it to be incorrectly disabled as broken, but there have been no reports of that. Cc: stable@xxxxxxxxxxxxxxx BugLink: https://bugzilla.kernel.org/show_bug.cgi?id=195895 Signed-off-by: Reimar Döffinger <Reimar.Doeffinger@xxxxxx> Tested-by: Paul Menzel <pmenzel@xxxxxxxxxxxxx> --- drivers/ata/libata-core.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/ata/libata-core.c b/drivers/ata/libata-core.c index eed65311b5d1..046faf0dbdd3 100644 --- a/drivers/ata/libata-core.c +++ b/drivers/ata/libata-core.c @@ -2007,7 +2007,7 @@ unsigned int ata_read_log_page(struct ata_device *dev, u8 log, retry: ata_tf_init(dev, &tf); - if (dev->dma_mode && ata_id_has_read_log_dma_ext(dev->id) && + if (ata_dma_enabled(dev) && ata_id_has_read_log_dma_ext(dev->id) && !(dev->horkage & ATA_HORKAGE_NO_DMA_LOG)) { tf.command = ATA_CMD_READ_LOG_DMA_EXT; tf.protocol = ATA_PROT_DMA; -- 2.33.0
