Resources such as clocks, PHYs, regulators are likely to get a probe
deferral return code, which could lead to the AHCI controller being
reset a few times until it gets successfully probed. Since this is
typically the most time consuming operation, move it after the resources
have been acquired.
Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
drivers/ata/ahci_brcm.c | 12 ++++++------
1 file changed, 6 insertions(+), 6 deletions(-)
diff --git a/drivers/ata/ahci_brcm.c b/drivers/ata/ahci_brcm.c
index 7ac1141c6ad0..e32c8fe729ff 100644
--- a/drivers/ata/ahci_brcm.c
+++ b/drivers/ata/ahci_brcm.c
@@ -456,13 +456,9 @@ static int brcm_ahci_probe(struct platform_device *pdev)
if (IS_ERR(priv->rcdev))
return PTR_ERR(priv->rcdev);
- reset_control_deassert(priv->rcdev);
-
hpriv = ahci_platform_get_resources(pdev, 0);
- if (IS_ERR(hpriv)) {
- ret = PTR_ERR(hpriv);
- goto out_reset;
- }
+ if (IS_ERR(hpriv))
+ return PTR_ERR(hpriv);
hpriv->plat_data = priv;
hpriv->flags = AHCI_HFLAG_WAKE_BEFORE_STOP | AHCI_HFLAG_NO_WRITE_TO_RO;
@@ -479,6 +475,10 @@ static int brcm_ahci_probe(struct platform_device *pdev)
break;
}
+ ret = reset_control_deassert(priv->rcdev);
+ if (ret)
+ return ret;
+
ret = ahci_platform_enable_clks(hpriv);
if (ret)
goto out_reset;
--
2.17.1
