I need to create subnodes for drives connected to SATA host controllers, and this needs to be supported generally, so create a common YAML binding for "sata" that will support subnodes with ports. This has been designed as a subset of ata/ahci-platform.txt with the bare essentials and should be possible to extend or superset to cover the common bindings. Cc: Rob Herring <robh+dt@xxxxxxxxxx> Cc: devicetree@xxxxxxxxxxxxxxx Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx> --- ChangeLog v2->v3: - Split off into its own RFC patch - Only support sata-port@ in this binding - Opt to support devices 0..14 on the sata-port in line with ahci-platforn.txt not modeling the port multiplier in the device tree at all. ChangeLog v1->v2: - Use ide@ and sata@ as node names. - Use ide-port@ and sata-port@ for the ports toward the drives, rather than letting the subnodes be the drives themselves. --- .../devicetree/bindings/ata/sata-common.yaml | 51 +++++++++++++++++++ 1 file changed, 51 insertions(+) create mode 100644 Documentation/devicetree/bindings/ata/sata-common.yaml diff --git a/Documentation/devicetree/bindings/ata/sata-common.yaml b/Documentation/devicetree/bindings/ata/sata-common.yaml new file mode 100644 index 000000000000..9f6718a69dfd --- /dev/null +++ b/Documentation/devicetree/bindings/ata/sata-common.yaml @@ -0,0 +1,51 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/ata/sata-common.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Common Properties for Serial AT attachment (SATA) controllers + +maintainers: + - Linus Walleij <linus.walleij@xxxxxxxxxx> + +description: | + This document defines device tree properties common to most Serial + AT attachment (SATA) storage devices. It doesn't constitue a device tree + binding specification by itself but is meant to be referenced by device + tree bindings. + + The SATA controller-specific device tree bindings are responsible for + defining whether each property is required or optional. + +properties: + $nodename: + pattern: "^sata(@.*)?$" + description: + Specifies the host controller node. SATA host controller nodes are named + "sata" + + "#address-cells": + const: 1 + + "#size-cells": + const: 0 + +patternProperties: + "^sata-port@[0-1]$": + description: | + DT nodes for ports connected on the SATA host. The master drive will have + ID number 0 and the slave drive will have ID number 1. The SATA port + nodes will be named "sata-port". + type: object + + properties: + reg: + minimum: 0 + maximum: 14 + description: + The ID number of the drive port SATA can potentially use a port + multiplier making it possible to connect up to 15 disks to a single + SATA port. + +... -- 2.21.0
