[PATCH v2 1/2] ata: ahci_brcm: Perform reset after obtaining resources

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Resources such as clocks, PHYs, regulators are likely to get a probe
deferral return code, which could lead to the AHCI controller being
reset a few times until it gets successfully probed. Since this is
typically the most time consuming operation, move it after the resources
have been acquired.

Signed-off-by: Florian Fainelli <f.fainelli@xxxxxxxxx>
---
 drivers/ata/ahci_brcm.c | 14 ++++++--------
 1 file changed, 6 insertions(+), 8 deletions(-)

diff --git a/drivers/ata/ahci_brcm.c b/drivers/ata/ahci_brcm.c
index 13ceca687104..70e3e386d52e 100644
--- a/drivers/ata/ahci_brcm.c
+++ b/drivers/ata/ahci_brcm.c
@@ -453,15 +453,9 @@ static int brcm_ahci_probe(struct platform_device *pdev)
 	else
 		reset_name = "ahci";
 
-	priv->rcdev = devm_reset_control_get(&pdev->dev, reset_name);
-	if (!IS_ERR_OR_NULL(priv->rcdev))
-		reset_control_deassert(priv->rcdev);
-
 	hpriv = ahci_platform_get_resources(pdev, 0);
-	if (IS_ERR(hpriv)) {
-		ret = PTR_ERR(hpriv);
-		goto out_reset;
-	}
+	if (IS_ERR(hpriv))
+		return PTR_ERR(hpriv);
 
 	hpriv->plat_data = priv;
 	hpriv->flags = AHCI_HFLAG_WAKE_BEFORE_STOP | AHCI_HFLAG_NO_WRITE_TO_RO;
@@ -478,6 +472,10 @@ static int brcm_ahci_probe(struct platform_device *pdev)
 		break;
 	}
 
+	priv->rcdev = devm_reset_control_get(&pdev->dev, reset_name);
+	if (!IS_ERR_OR_NULL(priv->rcdev))
+		reset_control_deassert(priv->rcdev);
+
 	ret = ahci_platform_enable_clks(hpriv);
 	if (ret)
 		goto out_reset;
-- 
2.17.1




[Index of Archives]     [Linux Filesystems]     [Linux SCSI]     [Linux RAID]     [Git]     [Kernel Newbies]     [Linux Newbie]     [Security]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Samba]     [Device Mapper]

  Powered by Linux