One of the requirement for modern x86 system to enter lowest power mode (SLP_S0) is SATA IP block to be off. This is true even during when platform is suspended to idle and not only in opportunistic (runtime) suspend. Several of these system don't have traditional ACPI S3, so it is important that they enter SLP_S0 state, to avoid draining battery even during suspend. So it is important that out of the box Linux installation reach this state. SATA IP block doesn't get turned off till SATA is in DEVSLP mode. Here user has to either use scsi-host sysfs or tools like powertop to set the sata-host link_power_management_policy to min_power. This change sets by default link power management policy to min_power with partial (preferred) or slumber support on idle for some platforms. To avoid regressions, the following conditions are used: - User didn't override the policy from module parameter - The kernel config is already set to use med_power_with_dipm or deeper - System is a SLP_S0 capable using ACPI low power idle flag This combination will make sure that systems are fairly recent and since getting shipped with SLP_S0 support, the DEVSLP function is already validated. Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@xxxxxxxxxxxxxxx> --- drivers/ata/ahci.c | 38 +++++++++++++++++++++++++++++++++----- 1 file changed, 33 insertions(+), 5 deletions(-) diff --git a/drivers/ata/ahci.c b/drivers/ata/ahci.c index 738fb22978dd..b14dccda0154 100644 --- a/drivers/ata/ahci.c +++ b/drivers/ata/ahci.c @@ -609,7 +609,7 @@ static int marvell_enable = 1; module_param(marvell_enable, int, 0644); MODULE_PARM_DESC(marvell_enable, "Marvell SATA via AHCI (1 = enabled)"); -static int mobile_lpm_policy = CONFIG_SATA_MOBILE_LPM_POLICY; +static int mobile_lpm_policy = -1; module_param(mobile_lpm_policy, int, 0644); MODULE_PARM_DESC(mobile_lpm_policy, "Default LPM policy for mobile chipsets"); @@ -1550,6 +1550,37 @@ static int ahci_init_msi(struct pci_dev *pdev, unsigned int n_ports, return pci_alloc_irq_vectors(pdev, 1, 1, PCI_IRQ_MSIX); } +static void ahci_update_initial_lpm_policy(struct ata_port *ap, + struct ahci_host_priv *hpriv) +{ + int policy = CONFIG_SATA_MOBILE_LPM_POLICY; + + + /* Ignore processing for non mobile platforms */ + if (!(hpriv->flags & AHCI_HFLAG_IS_MOBILE)) + return; + + /* user modified policy via module param */ + if (mobile_lpm_policy != -1) { + policy = mobile_lpm_policy; + goto update_policy; + } + +#ifdef CONFIG_ACPI + if (policy > ATA_LPM_MED_POWER && + (acpi_gbl_FADT.flags & ACPI_FADT_LOW_POWER_S0)) { + if (hpriv->cap & HOST_CAP_PART) + policy = ATA_LPM_MIN_POWER_WITH_PARTIAL; + else if (hpriv->cap & HOST_CAP_SSC) + policy = ATA_LPM_MIN_POWER; + } +#endif + +update_policy: + if (policy >= ATA_LPM_UNKNOWN && policy <= ATA_LPM_MIN_POWER) + ap->target_lpm_policy = policy; +} + static int ahci_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) { unsigned int board_id = ent->driver_data; @@ -1747,10 +1778,7 @@ static int ahci_init_one(struct pci_dev *pdev, const struct pci_device_id *ent) if (ap->flags & ATA_FLAG_EM) ap->em_message_type = hpriv->em_msg_type; - if ((hpriv->flags & AHCI_HFLAG_IS_MOBILE) && - mobile_lpm_policy >= ATA_LPM_UNKNOWN && - mobile_lpm_policy <= ATA_LPM_MIN_POWER) - ap->target_lpm_policy = mobile_lpm_policy; + ahci_update_initial_lpm_policy(ap, hpriv); /* disabled/not-implemented port */ if (!(hpriv->port_map & (1 << i))) -- 2.17.1 -- To unsubscribe from this list: send the line "unsubscribe linux-ide" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html