Hi,
On 02-07-18 22:21, Tejun Heo wrote:
On Mon, Jul 02, 2018 at 12:08:45PM -0700, Srinivas Pandruvada wrote:
From: Srinivas <srinivas.pandruvada@xxxxxxxxxxxxxxx>
One of the requirement for modern x86 system to enter lowest power mode
(SLP_S0) is SATA IP block to be off. This is true even during when
platform is suspended to idle and not only in opportunistic (runtime)
suspend.
Several of these system don't have traditional ACPI S3, so it is
important that they enter SLP_S0 state, to avoid draining battery even
during suspend even with out of the box Linux installation.
Question can systems which do have S3 not also enter SLP_S0 state during
normal operation to save power?
I guess the change of that happening without being in a suspend like state
(screen turned off, etc), is very small because there will always be
something blocking entering of SLP_S0, so that it is not worth
bothering looking into SLP_S0 on systems which use S3 for suspend ?
SATA IP block doesn't get turned off till SATA is in DEVSLP mode. Here
user has to either use scsi-host sysfs or tools like powertop to set
the sata-host link_power_management_policy to min_power.
This change sets by default link power management policy to min_power
for some platforms. To avoid regressions, the following conditions
are used:
- The kernel config is already set to use med_power_with_dipm or deeper
- System is a modern standby system using ACPI low power idle flag
- The platform is not blacklisted for Suspend to Idle and suspend
to idle is used instead of S3
This combination will make sure that systems are fairly recent and
since getting shipped with modern standby standby, the DEVSLP function
is already validated.
Signed-off-by: Srinivas Pandruvada <srinivas.pandruvada@xxxxxxxxxxxxxxx>
Seems sane to me. Hans, what do you think?
I think this is going in the right direction, but min_power enables
both DEVSLP and HIPM, AFAIK Windows at least in the past did not
enable HIPM be default.
Srinivas can you figure out what Windows does wrt HIPM?
We may need a new med_power_with_dipm_and_devslp level if windows does
not enable HIPM by default on these systems. In hind sight we really
should have separate bools for each, rather then coding this in
a single level, ah well.
Regards,
Hans
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
