On 10/19/2016 12:05 PM, Tejun Heo wrote:
Hello,
On Mon, Oct 17, 2016 at 11:27:28AM -0700, Adam Manzanares wrote:
Patch adds an association between iocontext ioprio and the ioprio of a
request. This is done to enable request based drivers the ability to
act on priority information stored in the request. An example being
ATA devices that support command priorities. If the ATA driver discovers
that the device supports command priorities and the request has valid
priority information indicating the request is high priority, then a high
priority command can be sent to the device. This should improve tail
latencies for high priority IO on any device that queues requests
internally and can make use of the priority information stored in the
request.
The ioprio of the request is set in blk_rq_set_prio which takes the
request and the ioc as arguments. If the ioc is valid in blk_rq_set_prio
then the iopriority of the request is set as the iopriority of the ioc.
In init_request_from_bio a check is made to see if the ioprio of the bio
is valid and if so then the request prio comes from the bio.
Signed-off-by: Adam Manzananares <adam.manzanares@xxxxxxx>
Jens, if you're okay with it, I can route this through
libata/for-4.10, or this can be applied to block and libata tree can
pull from it.
I'm fine with that, add my Reviewed-by and funnel it through the libata
tree.
--
Jens Axboe
--
To unsubscribe from this list: send the line "unsubscribe linux-ide" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
